Abstract:Computational analysis of transient phenomenon followed by the periodic state of laminar flow and heat transfer due to a rectangular rotating object in a square cavity is investigated. A finite-volume-based fixed-grid/sliding mesh computational methodology utilizing primitive variables is used. Rectangular rotating objects with different aspect ratios (AR = 1, 2, 3, 4) are placed in the middle of a square cavity. The motionless object is set in rotation at time t = 0 with a constant angular velocity. For the insulated and isothermal objects, the cavity is maintained as differentially-heated and isothermal enclosures, respectively. Natural convection heat transfer is neglected. For a given shape of the object and a constant angular velocity, a range of rotating Reynolds numbers are covered for a Pr = 5 fluid. The Reynolds numbers were selected so that the flow field is not affected by the Taylor instabilities (Ta < 1750). The periodic flow field, the interaction of the rotating objects with the recirculating vortices at the four corners and the periodic channelling effect of the traversing vertices are clearly elucidated. The corresponding thermal fields in relation to the evolving flow patterns and the skewness of the temperature contours in comparison to conduction-only case were discussed. The skewness is observed to become more marked as the Reynolds number is lowered. Transient variations of the average Nusselt numbers of the respective systems show that for high Re numbers, a quasi-periodic behavior due to the onset of the Taylor instabilities is dominant, whereas for low Re numbers, periodicity of the system is clearly observed. Time-integrated average Nusselt numbers of the insulated and isothermal object systems were correlated to the rotational Reynolds number and the aspect ratio of the rectangle. For high Re numbers, the performance of the system is independent of the aspect ratio. On the other hand, with lowering of the hydraulic diameter (i.e. bigger objects), objects with the highest and lowest aspect ratios exhibit the highest and lowest heat transfer, respectively. High intensity of the periodic channelling and not its frequency are identified as the cause of the observed enhancement.

Influence of the Switch-Over Period of an Alternately Active Bi-Heater on Heat Transfer Enhancement Inside a Cavity

Periodic Fluid Flow And Heat Transfer In A Square Cavity Due To An Insulated Or Isothermal Rotating Rectangular Object

Numerical and experimental study of inverse natural convection heat transfer for heat sink in a cavity with phase change material

Thermal response to periodic heating of a heat sink incorporating a phase change material

MHD convective heat transfer in a discretely heated square cavity with conductive inner block using two-phase nanofluid model

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation

The Role of Heater Size and Location in Modulating Natural Convection Behavior in Cu-Water Nanofluid-Loaded Square Enclosures

Computational study on transient thermal performance enhancement of phase change materials in triplex tube heat exchanger through novel annular-finned configurations

Experimental and numerical investigations on the intermittent heat transfer performance of rectangular cavity plate fin phase change material based heat sink

Numerical Investigation of Heat Transfer in Wire and Tube based Phase Change Material Heat Exchanger

Off-lattice Boltzmann simulation of conjugate heat transfer for natural convection in two-dimensional cavities

Thermal Performance of a Phase Change Material-Based Heat Sink Subject to Constant and Power Surge Heat Loads: A Numerical Study

Thermal performance augmentation of honeycomb metal matrix embedded phase change material in shell-tube latent heat storage unit

Mixed Convective Heat Transfer Enhancement in a Ventilated Cavity by Flow Modulation via Rotating Plate

Magneto-hydrothermal convective dynamics of hybrid nanofluid-packed partially cooled porous cavity: effect of half-sinusoidal heating

Interactive Influence of Conduction–Convection–Radiation on Heat Transfer from a Discretely and Non-Identically Heated Electronic Gadget

Effect of the time-dependent volumetric heat flux on heat transfer performance inside a heat sink based on the phase change materials

Forced convection heat transfer from confined circular/semi‐circular heaters and coolers with various orientations

Thermal design of a novel heat sink cooled by natural convection with phase transition in the series loop

Numerical Investigation on Thermal Performance of PCM-Based Hybrid Microchannel Heat Sinks for Electronics Cooling Application

An experimental study for thermal management using hybrid heat sinks based on organic phase change material, copper foam and heat pipe