Abstract:Material microstructures often contain non-uniformly distributed features of complex geometry. Attributes of three-dimensional microstructural geometry have dominant influence on the mechanical behavior of materials. Therefore, it is of interest to incorporate quantitative description of actual three-dimensional microstructures in micromechanical analysis of materials. In this contribution, a methodology has been developed to perform finite element (FE)-based simulations on complex three-dimensional microstructures, through its application to cast microstructure of A356 Al-alloy containing non-uniformly distributed pores of complex geometry. As expected, the simulations reveal that the distributions of local stresses and strains depend on size, orientation, and spatial arrangement of the pores in a complex manner. FE-simulations on the three-dimensional pore structure have been used to simulate the growth of the voids by the McClintock rule. These simulations clearly demonstrate that unit cell model can be used in the study the void growth behavior of materials at the stress levels close to global yield stress, and it overestimates the void growth at the stress levels significantly higher global yield stress. The FE-simulations reveal a general trend that larger voids have a higher percentage increase in their volume. Therefore, at a given applied stress level, absolute rate of volume change of a pore increases with its initial pore volume in a non-linear manner. These observations are supported by experimental measurements of pore growth. It is shown that micromechanical response does not vary significantly if the pores are replaced by equivalent ellipsoids, and such a model can be used to simulate the growth of non-uniformly distributed voids of complex geometry at all stress levels.

An Introduction to Micromechanics

Micromechanics of Materials, with Applications

Micromechanics of complex three-dimensional microstructures

A micromechanics-enhanced finite element formulation for modelling heterogeneous materials

A statistical descriptor based volume-integral micromechanics model of heterogeneous material with arbitrary inclusion shape

On Micropolar Elastic Foundations

$μ$MECH Micromechanics Library

Hybrid discrete-to-continuum viscoelastic viscoplasticity by volume constraint

Damage Micromechanics for Constitutive Relations and Failure of Microcracked Quasi-Brittle Materials

Inherent Symmetry and Microstructure Ambiguity in Micromechanics

Micromechanics of Magnetoelectroelastic Composite Materials: Average Fields and Effective Behavior

MICRO/MACROMECHANICAL PLASTIC LIMIT ANALYSES OF COMPOSITE MATERIALS AND STRUCTURES

Analytical and Numerical Investigations of Two Special Classes of Generalized Continuum Media

A general dynamic theoretical model of elastic micro-structures with consideration of couple stress effects and its application in mechanical analysis of size-dependent properties

A three-dimensional computational multiscale micromorphic analysis of porous materials in linear elasticity

A micromechanical scheme with nonlinear concentration functions by physics-guided neural network

A computational approach to identify the material parameters of the relaxed micromorphic model

On the Microscopic Foundations of Elasticity

Macroscopic model with anisotropy based on micro-macro informations

Micromechanics of machining and wear in hard and brittle materials