Abstract:Owing to its cost-effectiveness and adjustable eight-electron distribution in the 3d orbital, nickel oxide (NiO) is considered an effective electrocatalyst for an ambient electrochemical nitrogen reduction reaction (NRR). However, because of the low conductivity of the transition metal oxide electrocatalyst, its application in this field is limited. In this study, we found that the doping of NiO nanosheets with a small amount (3–10 nm) of Pt nanoparticles (Pt/NiO-NSs) leads to considerable improvements in the Faradaic efficiency (FE) and NH3 yield compared with those obtained using pure NiO, breaking the common perception that commercial Pt-based electrocatalysts demonstrate little potential for NRR due to their high hydrogen evolution tendency. In a 0.1 mol/L Na2SO4 solution at −0.2 V vs. RHE, a typical Pt/NiO-2 sample exhibits an optimum electrochemical NH3 yield of 20.59 μg h–1 mg–1cat. and an FE of 15.56%, which are approximately 5 and 3 times greater, respectively, than those of pure NiO nanosheets at the same applied potential. X-ray photoelectron spectroscopy analysis revealed that Pt in Pt/NiO-NSs exist as Pt0, Pt2+, and Pt4+ and that high-valence Pt ions are more electropositive, thereby favoring chemisorption and the activation of N2 molecules. Density function theory calculations showed that the d-band of Pt nanoparticles supported on NiO is significantly tuned compared to that of pure Pt, affording a more favorable electronic structure for NRR. The results of this study show that Pt can be an effective NRR electrochemical catalyst when loaded on an appropriate substrate. Most importantly, it provides a new synthetic avenue for the fabrication of highly active Pt-based NRR electrocatalysts.Graphical Mesoporous NiO nanosheets loaded with Pt nanoparticles were explored as electrocatalysts for nitrogen reduction reaction (NRR), providing a new synthetic avenue for fabricating highly active Pt-based NRR electrocatalysts.Download : Download high-res image (122KB)Download : Download full-size image

Efficient Electrocatalytic Ammonia Synthesis via Theoretical Screening of Titanate Nanosheet-Supported Single-Atom Catalysts

Theory-Guided Construction of the Unsaturated V-N<sub>2</sub> Site with Carbon Defects for Highly Selective Electrocatalytic Nitrogen Reduction

Enhancing Electrocatalytic Ammonia Synthesis through Theoretical Design of Cluster Catalysts Supported on TiO 2 Surface

Theoretical screening of cooperative N-bridged dual-atom sites for efficient electrocatalytic nitrogen reduction with remolding insight

Single-Atomic Ruthenium Active Sites on Ti<sub>3</sub>C<sub>2</sub> MXene with Oxygen-Terminated Surface Synchronize Enhanced Activity and Selectivity for Electrocatalytic Nitrogen Reduction to Ammonia

Au Sub-Nanoclusters on TiO 2 toward Highly Efficient and Selective Electrocatalyst for N 2 Conversion to NH 3 at Ambient Conditions.

Modulating Nitrogen Adsorption Mode and Microenvironment of Active Sites for Boosting Electrochemical Nitrogen Reduction

Transition Metal-Tetracyanoquinodimethane Monolayers as Single-Atom Catalysts for Electrocatalytic Nitrogen Reduction Reaction

High-Throughput Screening of Nitrogen Reduction Reaction on Single Atom@1T'-MoS 2

High-Efficiency Electrosynthesis of Ammonia with High Selectivity under Ambient Conditions Enabled by VN Nanosheet Array

Single-atom Catalyst of TM@D-silicene-an Effective Way to Reduce N2 into Ammonia.

Theoretical exploration of the nitrogen fixation mechanism of two-dimensional dual-metal TM1TM2@C9N4 electrocatalysts

A novel porous graphitic carbon nitride (g-C7N3) substrate: prediction of metal-based π–d conjugated nanosheets toward the highly active and selective electrocatalytic nitrogen reduction reaction

Ruthenium/titanium Oxide Interface Promoted Electrochemical Nitrogen Reduction Reaction

Electrocatalytic ammonia synthesis catalyzed by mesoporous nickel oxide nanosheets loaded with Pt nanoparticles

Isolated Rhodium Atoms Activate Porous TiO2 for Enhanced Electrocatalytic Conversion of Nitrate to Ammonia

Selective Electrochemical Reduction of Nitrogen to Ammonia by Adjusting the Three-Phase Interface

Tuning transition metal atoms embedded in N6 cavity structure toward efficient electrocatalytic ammonia synthesis

Heterogeneous Electrocatalysts Design for Nitrogen Reduction Reaction under Ambient Conditions

High-throughput identification of high activity and selectivity transition metal single-atom catalysts for nitrogen reduction

High Throughput Screening of Transition Metal Binuclear Site for N2 Fixation