Numerical Analysis of New PCM Thermal Storage Systems

Giampietro Fabbri,Matteo Greppi,Federico Amati

DOI: https://doi.org/10.3390/en17071772

IF: 3.2

2024-04-09

Energies

Abstract:In this paper, a thermal storage system based on a phase change material is proposed and investigated. The system is composed of several tubes that cross a phase change material mass. A fluid flowing in the tubes charges and discharges the heat storage system. A mathematical model of the system has been developed, which provides the time and space distribution of velocity, temperature, and liquid phase-changing material concentration in a non-stationary regime. A hybrid solution method based on finite volumes and finite differences techniques has been employed for the model equations in the MATLAB environment. To the tubes, a rectangular cross section has been assigned. The performance of the system in terms of accumulated energy density and accumulated power density has been investigated by varying some geometric parameters. The considered geometric parameters influence the number of tubes per unit of system width, the tube hydraulic resistance, the amount of phase change material around each tube, the heat transfer surface of the tube, and the heat storage velocity. In the parametric analysis, peaks have been evidenced in the investigated performance parameters at different instants after the beginning of the heat storage.

energy & fuels

What problem does this paper attempt to address?

The paper attempts to address the problem of optimizing the performance of thermal energy storage systems based on phase change materials (PCM). Specifically, the researchers propose and analyze a thermal energy storage system composed of multiple metal tubes passing through the phase change material. By altering some geometric parameters (such as the number of tubes, hydraulic resistance of the tubes, the amount of phase change material, the heat exchange area of the tubes, and the heat storage rate), the researchers aim to improve the system's energy density and power density.

### Main Research Content:
1. **System Design**:
- The system consists of 10 thin-walled metal tubes with rectangular cross-sections, which pass through the phase change material.
- The external part of the tubes is long enough to ensure fully developed internal flow distribution, and the external part is insulated.

2. **Mathematical Model**:
- A mathematical model was developed to describe the spatial and temporal distribution of velocity, temperature, and liquid phase material concentration under unsteady conditions.
- The model equations were solved using the finite volume method and finite difference method in the MATLAB environment.

3. **Parameter Analysis**:
- By changing geometric parameters (such as Ly1, Lz, and Lz1), the impact of these parameters on system performance was studied.
- The cumulative energy density and cumulative power density at different time points were analyzed, and some peaks were identified.

### Objectives:
- **Improve Energy Density**: By optimizing geometric parameters, increase the energy stored per unit volume.
- **Improve Power Density**: By optimizing geometric parameters, increase the instantaneous power output per unit volume.

### Conclusions:
- Changing geometric parameters can significantly affect the thermal energy storage performance of the system.
- The optimized system can exhibit better performance both in the initial stage and during long-term operation.

Overall, through numerical analysis and parameter optimization, this paper aims to design an efficient, high energy density, and high power density phase change material thermal energy storage system.