Abstract:<p>As it is usually operating in bad working conditions and subjected to the severe interference from diverse paths, internal faults of the hydraulic valve are difficult to be detected using conventional hydraulic testing technology (such as relying on pressure sensors or flow sensors). Moreover, the information collected from a single sensor may not provide accurate diagnostic evidence or a complete description on faults of hydraulic valves, even though employing intelligent fault diagnosis methods. Therefore, a two-stage multi-sensor information fusion method is proposed, including the fault feature fusion and the decision-making information fusion. The aim is to realize the diagnosis on internal faults of hydraulic directional valves using the vibration signal analysis method instead of conventional hydraulic testing ones. The method is mainly divided into three steps. First, the noise reduction of the vibration information collected by multiple acceleration sensors is done using ensemble empirical mode decomposition (EEMD) and Teager-Kaiser energy operator (TEO), so that fault features are more obvious. Then, multi-class fault features including the severity and the location of the wear are extracted from the preprocessing signals to form the original feature set. Second, combined with feature ranking and subset selection based on euclidean distance (FRSSED) and maximum relevance minimum redundancy (mRMR) feature selection method, the statistical features extracted from multiple sensor signals are optimized to form the optimal feature subset. This is the first-level information fusion concerned with fault feature information fusion. In the third step, based on Dempster-Shafer (DS) evidence theory and convolutional neural network (CNN), decision-making information is fused (called second-level information fusion) to obtain the final diagnosis results. A hydraulic test bench is built to test different failure valves. Experimental results indicate that this method is effective in extracting the fault features from multi-sensor signals and detecting the fault states including severity and location of internal wear of the hydraulic valve.</p>

A novel data fusion based intelligent identification approach for working cycle stages of hydraulic excavators

Intelligent identification for working-cycle stages of excavator based on main pump pressure

Research on the Design and Control Strategy for a Flow-Coupling-based Hydraulic Hybrid Excavator

Energy saving scheme of hydraulic excavators based on hybrid power technology

Control Strategy of Hybrid Excavator Based on Condition Recognition and Hybridization Optimization

Fuzzy Logical Control Algorithm Based on Engine On/Off State Switch for Hybrid Hydraulic Excavator

Health State Identification of Circulating Seawater Pump-Unit in Nuclear Power Plant Based on Multi-Virtual Vibration Source Fusion in the Presence of Strong Data Imbalance

A Novel Hybrid Control Strategy for Potential Energy Regeneration Systems of Hybrid Hydraulic Excavators.

Design and Control of Hydraulic Hybrid System for Excavators

Modeling and Control of General Hydraulic Excavator for Human-in-the-loop Automation

LSTM-Based Workload Recognition for Hydraulic Actuators: A Case Study on Excavator Digging Process

A Novel Current-Based Identification Method for Dynamic Performance of High-Speed On/off Valve

Fault diagnosis in a hydraulic directional valve using a two-stage multi-sensor information fusion

The Load-Haul-dump Operation Cycle Recognition Based on Multi-Sensor Feature Selection and Bidirectional Long Short-Term Memory Network

A hydraulic motor fault diagnosis method based on weighted multi-channel information fusion

Fault Diagnosis of Hydraulic Components Based on Multi-Sensor Information Fusion Using Improved TSO-CNN-BiLSTM

Fault diagnosis of the hydraulic valve using a novel semi-supervised learning method based on multi-sensor information fusion

DSmT-based Three-Layer Method Using Multi-Classifier to Detect Faults in Hydraulic Systems

Parameter Matching and Control of Series Hybrid Hydraulic Excavator Based on Electro-Hydraulic Composite Energy Storage.

Multi-fault diagnosis and fault degree identification in hydraulic systems based on fully convolutional networks and deep feature fusion