Abstract:The dusty regolith covering the surfaces of asteroids and planetary satellites differs in size, shape, and composition from terrestrial soil particles and is subject to environmental conditions very different from those found on Earth. This regolith evolves in a low ambient pressure and low-gravity environment. Its response to low-velocity impacts, such as those that may accompany human and robotic exploration activities, may be completely different than what is encountered on Earth. Experimental studies of the response of planetary regolith in the relevant environmental conditions are thus necessary to facilitate future Solar System exploration activities.We combined the results and provided new data analysis elements for a series of impact experiments into simulated planetary regolith in low-gravity conditions using two experimental setups and a range of microgravity platforms. The Physics of Regolith Impacts in Microgravity Experiment (PRIME) flew on several parabolic aircraft flights, enabling the recording of impacts into granular materials at speeds of ∼ 4–230 cm/s. The COLLisions Into Dust Experiment (COLLIDE) is conceptually close to the PRIME setup. It flew on the Space Shuttle in 1998 and 2001 and more recently on the Blue Origin New Shepard rocket, recording impacts into simulated regolith at speeds between 1 and 120 cm/s.Results of these experimental campaigns found that there is a significant change in the regolith behavior with the gravity environment. In a 10 −2g environment (with g being the gravity acceleration at the surface of the Earth), only embedding of the impactor was observed and ejecta production was produced for most impacts at > 20 cm/s. Once at microgravity levels (<10−4g), the lowest impact energies also produced impactor rebound. In these microgravity conditions, ejecta started to be produced for impacts at > 10 cm/s. The measured ejecta speeds were somewhat lower than the ones measured at reduced-gravity levels, but the ejected masses were higher. In general, the mean ejecta velocity shows a power-law dependence on the impact energy with an index of ∼ 0.5. When projectile rebound occurred, we observed that its coefficients of restitution on the bed of regolith simulant decrease by a factor of 10 with increasing impact speeds from ∼ 5 up to 100 cm/s. We could also observe an increased cohesion between the JSC-1 grains compared to the quartz sand targets.

Tracking plume-regolith interactions in near-vacuum conditions

Investigating collision effects on lunar soil particles ejected under rocket plumes

Rocket Cratering in Simulated Lunar and Martian Environments

Lunar Dust Particles Blown By Lander Engine Exhaust in Rarefied and Compressible Flow

Regolith behavior under asteroid-level gravity conditions: low-velocity impact experiments

The Investigation of Plume-Regolith Interaction and Dust Dispersal during Chang'E-5 Descent Stage

Ejecta behavior during plume-surface interactions under rarefied atmospheric conditions

Lunar Cold Trap Contamination by Landing Vehicles

Measurement of micron-sized ejecta generated from oblique impact experiments with regolith simulant targets

Unveiling the Mechanics of Lunar Regolith Erosion Through Analysis of CE-4 and CE-5 Landing Images and Fluid Simulation

Scaling laws of plume-induced granular cratering

Cratering of Soil by Impinging Jets of Gas, with Application to Landing Rockets on Planetary Surfaces

Numerical investigation of impinging plume under vacuum and realistic nozzle outlet condition

Apollo Video Photogrammetry Estimation of Plume Impingement Effects (conference version)

Scaling of Erosion Rate in Subsonic Jet Experiments and Apollo Lunar Module Landings

Stick-slip dynamics in penetration experiments on simulated regolith

Numerical simulations of regolith sampling processes

Plume-surface interaction during lunar landing using a two-way coupled DSMC-DEM approach

Gas-particle Two-Way Coupled Method for Simulating the Interaction Between a Rocket Plume and Lunar Dust

Abstract Central-Abstract Proof PopUp

Instrument to Study Plume Surface Interactions (PSI) on the Lunar Surface: Science Motivation, Requirements, Instrument Overview, and Test Plans