Abstract:The dusty regolith covering the surfaces of asteroids and planetary satellites differs in size, shape, and composition from terrestrial soil particles and is subject to environmental conditions very different from those found on Earth. This regolith evolves in a low ambient pressure and low-gravity environment. Its response to low-velocity impacts, such as those that may accompany human and robotic exploration activities, may be completely different than what is encountered on Earth. Experimental studies of the response of planetary regolith in the relevant environmental conditions are thus necessary to facilitate future Solar System exploration activities.We combined the results and provided new data analysis elements for a series of impact experiments into simulated planetary regolith in low-gravity conditions using two experimental setups and a range of microgravity platforms. The Physics of Regolith Impacts in Microgravity Experiment (PRIME) flew on several parabolic aircraft flights, enabling the recording of impacts into granular materials at speeds of ∼ 4–230 cm/s. The COLLisions Into Dust Experiment (COLLIDE) is conceptually close to the PRIME setup. It flew on the Space Shuttle in 1998 and 2001 and more recently on the Blue Origin New Shepard rocket, recording impacts into simulated regolith at speeds between 1 and 120 cm/s.Results of these experimental campaigns found that there is a significant change in the regolith behavior with the gravity environment. In a 10 −2g environment (with g being the gravity acceleration at the surface of the Earth), only embedding of the impactor was observed and ejecta production was produced for most impacts at > 20 cm/s. Once at microgravity levels (<10−4g), the lowest impact energies also produced impactor rebound. In these microgravity conditions, ejecta started to be produced for impacts at > 10 cm/s. The measured ejecta speeds were somewhat lower than the ones measured at reduced-gravity levels, but the ejected masses were higher. In general, the mean ejecta velocity shows a power-law dependence on the impact energy with an index of ∼ 0.5. When projectile rebound occurred, we observed that its coefficients of restitution on the bed of regolith simulant decrease by a factor of 10 with increasing impact speeds from ∼ 5 up to 100 cm/s. We could also observe an increased cohesion between the JSC-1 grains compared to the quartz sand targets.

Numerical simulations of regolith sampling processes

A sweeping and grinding combined hybrid sampler for asteroid sample return mission

A Sweeping and Grinding Methods Combined Hybrid Sampler for Asteroid Exploration

Simulating regoliths in microgravity

Numerical simulation and experimental research on the wheel brush sampling process of an asteroid sampler

Stick-slip dynamics in penetration experiments on simulated regolith

Simulation and Analysis of the Lunar Regolith Sampling Process Based on the Discrete Element Method

CFD–DEM Simulation of Gas-Driven Sampling on Asteroid Regolith: Dependence of Collected Mass on Gas Ejection

Numerical Simulations of the Controlled Motion of a Hopping Asteroid Lander on the Regolith Surface

Gas-Driven Regolith-Sampling Strategy for Exploring Micro-Gravity Asteroids

Numerical Simulations of Highly Porous Dust Aggregates in the Low-Velocity Collision Regime

Regolith behavior under asteroid-level gravity conditions: low-velocity impact experiments

Simulations of Lunar Dust interaction with exploration systems and instruments

Numerical Study on Low-Velocity Impact Between Asteroid Lander and Deformable Regolith

Sputter Yields of the Lunar Surface: Experimental Validation and Numerical Modelling of Solar Wind Sputtering of Apollo 16 Soils

Lunar highlands simulant - geotechnical characterization, 3D discrete element modeling, and cone penetration simulations

An integrated DEM code for tracing the entire regolith mass movement on asteroids

Modeling of Migrating Grains on Asteroid’s Surface

Tracking plume-regolith interactions in near-vacuum conditions

Asteroid Surface Impact Sampling: Dependence of the Cavity Morphology and Collected Mass on Projectile Shape

SPH-based simulation of multi-material asteroid collisions