Abstract:In this research, high-strength stainless steel (HSSS) wires with ECC were used to strengthen the RC columns to take full advantage of two reinforcement materials and increase the ductility, load-carrying capacity, and durability of strengthened columns. To study strengthened columns' properties under large eccentric compression, seven specimens were devised and examined with various strengthening schemes, initial eccentricity, and reinforcement ratios of longitudinal HSSS wires. The experimental results showed a significant improvement in the performances of RC columns strengthened with HSSS wire-ECC than those RC columns strengthened only with ECC. These improvements included higher load-carrying capacity, better flexibility, excellent cracking control, satisfactory failure patterns, etc. Specifically, the RC column SCH4–0.3 reinforced with HSSS wire-ECC showed an increase in cracking load and peak load by 129.6 % and 120.4 %, respectively, compared to the original reinforced concrete column (ORC). Additionally, compared to the ECC-reinforced RC column, SCH4–0.3 showed increases of 34.8 % and 67.2 % in cracking load and peak load, respectively. In addition, the ductility of RC columns reinforced with HSSS wire-ECC (SCH3–0.4, SCH4–0.4, and SCH5–0.4) was increased by 53 %-78 % compared with ORC columns. Moreover, the cracking and peak loads of the RC column SCH4–0.3 reinforced with HSSS wire-ECC were 129.6 % and 120.4 % higher than those of the ORC column, and 34.8 % and 67.2 % greater than those of the ECC- ECC-strengthened RC column, respectively. In addition, the ductility of RC columns reinforced with HSSS wire-ECC (SCH3–0.4, SCH4–0.4, and SCH5–0.4) was increased by 53 %-78 % than that of unreinforced specimen ORC. The surface cracking of RC columns strengthened with HSSS wire-ECC was also more uniform. As the relative initial eccentricity improved (0.3–0.5), peak and crack loads of reinforced RC columns decreased. The peak loads of specimens SCH4–0.3 and SCH4–0.4 increased by 77 % and 38.8 %, respectively, compared with those of specimen SCH4–0.5. The results showed that the load-carrying capacity and ductility of RC columns strengthened with HSSS wire-ECC were significantly improved. Based on the distribution of strain and destroy form analyses, mechanical mechanism and the calculation procedure of normal section force of RC columns strengthened with HSSS wire-ECC were proposed. The calculated results and the measurement data were consistent and could be applied to reinforcement engineering practice.

Experimental study on improving the compressive property of damaged RC columns with prestressed SMA spirals

Study on reinforced concrete beams strengthened using shape memory alloy wires in combination with carbon-fiber-reinforced polymer plates

Uniaxial Compressive Behavior of Concrete Columns Confined with Superelastic Shape Memory Alloy Wires

Experimental study of simple concrete and reinforced concrete beams monitored and driven by shape memory alloy

Axial behavior of RC column strengthened with SM-CFST

Study of A Reinforced Concrete Beam Strengthened Using A Combination of Sma Wire and Cfrp Plate

Experimental Study on the Static Behavior and Recovery Properties of CFRP/SMA Composites

Experiment and Analysis of Smart Concrete Beam Strengthened Using Shape Memory Alloy Wires

Experimental Investigation on Bending Behavior of Existing RC Beam Retrofitted with SMA-ECC Composites Materials

The effect of shape memory alloys on the ductility of exterior reinforced concrete beam-column joints using the damage plasticity model

Flexural Performance of RC Beams Strengthened with Pre-Stressed Iron-Based Shape Memory Alloy (Fe-SMA) Bars: Numerical Study

Study on Damage Emergency Repair Performance of A Simple Beam Embedded with Shape Memory Alloys

Mechanical properties of RC columns strengthened with high-strength stainless steel wires-ECC under large eccentric loading

Experimental investigation on hysteretic properties and applications in beam-column connections of shape memory alloy plates

Behavior of A Simple Concrete Beam Driven by Shape Memory Alloy Wires

Experimental study on improving the fire performance of the concrete beams with Fe-SMA

Finite element modeling of reinforced concrete beams posttensioned with supplemental unbonded near surface mounted nickel‐titanium‐niobium shape memory alloy wire reinforcement

Shear strengthening of reinforced concrete beams using shape memory alloys

Study on flexural and self-repairing properties of shape memory alloy concrete beams

Experimental study on flexural behavior of RC beams strengthened with FRP/SMA composites

Experimental study on pre-damaged RC beams shear-strengthened with textile-reinforced mortar (TRM)