Abstract:This paper introduces a novel three‐phase grid‐tied Multilevel Inverter (MLI) topology that employs a basic unit per phase, yielding a symmetrical configuration capable of generating 5‐level output voltage, and an asymmetrical configuration producing 7‐level and 9‐level output voltages. The generalization of the proposed MLI is presented in terms of the number of modules (M) and output levels (L). A comprehensive comparative analysis of the proposed MLI topology against existing configurations is presented for both symmetric and asymmetric cases. To achieve synchronization a PLL less Grid Voltage Modulated Direct Power Control (GVM‐DPC) technique is implemented. This paper also includes mathematical modelling of GVM‐DPC without PLL and the design of an LCL filter. This paper introduces a novel three‐phase grid‐tied multilevel inverter (MLI) topology that employs a basic unit per phase, yielding a symmetrical configuration capable of generating five‐level output voltage and an asymmetrical configuration producing seven‐level and nine‐level output voltages. The generalization of the proposed MLI is presented in terms of the number of modules (M) and output levels (L). A comprehensive comparative analysis of the proposed MLI topology against existing configurations is presented for both symmetric and asymmetric cases. The switching devices in the MLI are controlled using the in‐phase disposition level shift PWM (IPD‐LSPWM) technique. The synchronization of the grid‐tied MLI is addressed by considering the uncertainties in grid and load parameters at the point of common coupling (PCC). To achieve synchronization, a PLL‐less grid voltage‐ modulated direct power control (GVM‐DPC) technique is implemented. To mitigate the delay associated with PLL, a GVM‐DPC based on the stationary reference frame (SRF) is applied. This paper also includes mathematical modelling of GVM‐DPC without PLL and the design of an LCL filter. A simulation model of a 15‐kVA, three‐phase, nine‐level grid‐tied MLI is developed in MATLAB/Simulink and tested under both steady‐state and dynamic conditions. The proposed controller's performance is evaluated under the load variations and sudden changes in available power from the distributed generator (DG). Robustness is tested under adverse conditions such as voltage sag/swell at the PCC. Furthermore, the system is implemented in the OPAL‐RT OP4510 real‐time simulator, and the results are validated to confirm the effectiveness and robustness of the proposed grid‐tied MLI.

An Interleaved Single-Stage Switched-Boost Common-Ground Multilevel Inverter: Design, Control, and Experimental Validation

A High Step-up Multilevel Inverter with Minimized Components Featuring Self-balancing and Continuous Input Current Capabilities

Reduced Switch‐count Structure for Symmetric Multilevel Inverters with a Novel Switched‐dc‐source Submodule

Switched-capacitor Multilevel Inverter with Self-Voltage-balancing for High-Frequency Power Distribution System

Seven‐level Boosting Active Neutral Point Clamped Inverter Using Cross‐connected Switched Capacitor Cells

A Single-Phase Common-Ground Five-Level Transformerless Inverter with Low Component Count for PV Applications

A Novel Boost Cascaded Multilevel Inverter

Single DC-link-based 5-level MLI topology for renewable and grid applications with fewer switches

A Novel Common‐Ground Switched‐Capacitor Type Dual‐Mode Five‐Level Transformer‐Less Multilevel Inverter

Common-Ground-Type Single-Source High Step-Up Cascaded Multilevel Inverter for Transformerless PV Applications

Generalized Switched-Capacitor-Based Hybrid Multilevel Inverter With Reduced Components Count and Inrush Current

A Reduced Switch Count Single-Source Seven-Level Switched-Capacitor Boost Multilevel Inverter with Extendibility

Advancements in Multilevel Inverters for Efficient Harnessing of Renewable Energy: A Comprehensive Review and Application Analysis

Improved Cascaded H-Bridge Multilevel Inverters with Voltage-Boosting Capability

A PLL‐less grid‐tied three‐phase multilevel inverter with reduced device count and LCL filter

Analysis and experimentation of a new three-phase multilevel current-source inverter

A new single-source, single-phase, 9-L 4-B switched capacitor-based multilevel inverter

A Modular Multilevel Converter with Boosting, Self-Balancing, and Scaling Capabilities for High- Voltage Transformerless PV Applications

Reduced switch single source multilevel inverter topology for renewable photovoltaic system applications

A New Boost Switched-Capacitor Multilevel Converter With Reduced Circuit Devices

Design and implementation of a reduced switch seventeen-level multilevel inverter for grid integration of battery storage system