Abstract:Objective: The aim of the present study was to evaluate the in situ/in vivo effect of quercetin on dentin erosion and abrasion. Methods: Human dentin blocks (2 × 2 × 2 mm) were embedded and assigned to 6 groups: 75 μg/mL, 150 μg/mL and 300 μg/mL quercetin (Q75, Q150, Q300); 120 μg/mL chlorhexidine (CHX, positive control); and deionized water and ethanol (the negative controls). The specimens were treated with the respective solutions for 2 min and then subjected to in situ/in vivo erosive/abrasive challenge for 7 d as follows: in vivo erosion 4 times a day and then in vivo toothbrush abrasion after the first and last erosive challenges of each day. Dentin loss was assessed by profilometry. An additional dentin specimen was used to evaluate the penetration depth of quercetin into dentin by tracking the spatial distribution of its characteristic Raman peak. Moreover, dentin blocks (7 × 1.7 × 0.7 mm) were used to detect the impact of quercetin on dentin-derived matrix metalloproteinase (MMP) inhibition by in situ zymography, and the inhibition percentage (%) was calculated. Additionally, the potential collagen crosslinking interactions with quercetin were detected by Raman spectroscopy, and the crosslinking degree was determined with a ninhydrin assay. Fully demineralized dentin beams (0.5 × 0.5 × 10 mm) were used to evaluate the impact of quercetin on the mechanical properties of dentin collagen fibre by the ultimate micro-tensile strength test (μUTS). The data were analysed by one-way analysis of variance and Tukey's test (α = 0.05). Results: Compared to the negative controls, all treatment solutions significantly reduced dentin loss. The dentin loss of Q150 and Q300 was significantly less than that of CHX (all P < 0.05). The amount of quercetin decreased with increasing dentin depth, and the maximum penetration depth was approximately 25-30 µm. In situ zymography showed that quercetin significantly inhibited the activities of dentin-derived MMPs. The inhibitory percentages of Q75 and Q150 were significantly lower than that of CHX (all P < 0.05), but no significant difference was found between Q300 and CHX (P = 0.58). The collagen crosslinking interactions with quercetin primarily involved hydrogen bonding and the degree of crosslinking increased in a concentration-dependent manner. Statistically significant increases in μUTS values were observed for demineralized dentin beams after quercetin treatment compared with those of the control treatments (all P < 0.05). Significance: This study provides the first direct evidence that quercetin could penetrate approximately 25-30 µm into dentin and further prevent dentin erosion and abrasion by inhibiting dentin-derived MMP activity as well as crosslinking collagen of the demineralized organic matrix.

Effect of Polyphenols on the Ultrastructure of the Dentin Pellicle and Subsequent Erosion

The Effect of Polyphenol-Containing Solutions on in Situ Biofilm Formation on Enamel and Dentin

The effect of acidic beverages on the ultrastructure of the acquired pellicle--an in situ study

Synergistic effect between plant extracts and fluoride to protect against enamel erosion: An in vitro study

Dual protective effect of the association of plant extracts and fluoride against dentine erosion: In the presence and absence of salivary pellicle

The effect of different conditioning agents on dentin roughness and collagen structure

Study on the adverse effect of acid-corrosion on the dentin in terms of degradation of fracture resistance

Fluoride Release and Anti-Erosive Effects of Dentifrices Containing PVM/MA Copolymers.

Biomineralization induced by chitosan and collagen-based materials with fluoride for dentin coverage: Chemical and morphological analysis

Protective Effects of Resin Sealant and Flowable Composite Coatings Against Erosive and Abrasive Wear of Dental Hard Tissues.

Comparison of Resistance of Dentin to Erosive Acid after Application of Fluoride to Teeth

Effects of desensitizing dentifrices on dentin tubule occlusion and resistance to erosive challenges

The Impact of Stannous, Fluoride Ions and Its Combination on Enamel Pellicle Proteome and Dental Erosion Prevention

Characteristics of tin-containing fluoride toothpastes related to erosive tooth wear protection

Epigallocatechin-3-gallate Enhance Dentin Biomodification and Bond Stability of an Etch-and-rinse Adhesive System

Effects of Experimental Agents Containing Tannic Acid or Chitosan on the Bacterial Biofilm Formation in Situ

Impact of Acquired Pellicle Modification on Adhesion of Early Colonizers

Impact of pH-adjusted fluoride and stannous solutions on the protective properties on the pellicle layer in vitro and in situ

To etch or not to etch, Part II: On the hydrophobic-rich content and fatigue strength of universal adhesives

[Effect of Tea Polyphenol on the Demineralization and Remineralization of Enamel in Vitro].

Dual function of quercetin as an MMP inhibitor and crosslinker in preventing dentin erosion and abrasion: An in situ/in vivo study