Abstract:One of the most important methods for evaluating the insulation condition of power equipment is the on-site partial discharge test. Fiber-optic sensors based on various principles have been developed to detect the acoustic signal of partial discharge due to their high immunity to electromagnetic interference and ability to be embedded within power equipment capabilities. A novel distributed fiber-optic acoustic sensor based on phase-sensitive optical time-domain reflectometry <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">${\Phi}$</tex> -OTDR) was proposed in this paper for the detection of partial discharge acoustics on power cable joints. The <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">${\Phi}$</tex> -OTDR-based partial discharge acoustic detection system measured the coherent Rayleigh backscattered (RBS) light in a single-mode optical fiber route, which carries the acoustic perturbation occurrences somewhere along the fiber route, and is transmitted back to the near-end of the optical fiber. The target phase shift-collected by the distributed fiber-optic sensors under partial discharge- induced acoustic perturbations is present in both the amplitude- modulated and phase-modulated terms of the RBS signal, and then the acoustic-related phase shift terms can be demodulated by introducing the Hilbert transform based signal processing algorithms. Its effectiveness for partial discharge ultrasonic detection of 15 kV cable joints has been validated, and the <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">${\Phi}{-}$</tex> OTDR detection system was also used to measure the stress cone dislocation defect of a 220 kV cable joint, and the test results of the piezoelectric measurement method were compared to validate the effectiveness of <tex xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">${\Phi}$</tex> -OTDR distributed fiber sensors. The experimental results show that the proposed distributed fiber-optic sensing system can effectively detect and locate the partial discharge signal.

Optical fiber sensors for the electric power industry

Fiber-optic voltage sensor for SF6 gas-insulated high-voltage switchgear

Optical Current Transducer For Electric Power System

An Optical Fiber Sensor For Electrification Measurement In Power Transformers

A Fiber-Optic Sensor for Acoustic Emission Detection in a High Voltage Cable System

Research on Fiber Optic Sensors in Power System

Advances in SPR-based Fiber Optic Sensors for Voltage/Electric Field Measurement – A Review

Fiber Optical Intensity Sensors

Measurement of Electrical Current with Optic Fiber Technology

Resonant Fiber Optic Current Sensor Based on Broadband Light Source

Optical fibre sensors and systems for industry

Recent Progress in Distributed Fiber Optic Sensors

Temperature dependence of optical fiber current sensor with external conversion

Application of Acousto-optical Partial Discharge Detection to High Voltage Equipment

A Novel Optical Fiber Electric Field Sensor

Design and Electric-Field Analysis of a Reflective 500 kV All-Fiber Voltage Sensor

A Distributed Fiber Sensing System for Acoustic Emission and Vibration of Power Equipment

Vibration Immunity Fiber Optic Current Sensor Employing a Spun or Twisted Highly Linear Birefringence Fiber

Fiber-coupled LED gas sensor and its application to online monitoring of ecoefficient dielectric insulation gases in high-voltage circuit breakers

Distributed Fiber-Optic Sensing for Partial Discharge Detection of Stress Cone Dislocation Defects in High Voltage Cable Joints

Optical Fibre-Based Sensors-An Assessment of Current Innovations