Abstract:High-temperature features are crucial for evaluating the performance of emulsified asphalt. As effective binders, evaporation residues directly determine the high-temperature performance of emulsified asphalt. This study aims to systematically investigate the laboratory preparation process for different emulsified asphalt evaporation residues (EAERs) and proposes appropriate testing and evaluation methods. First, emulsified asphalt was prepared using five different material samples (cations M, A, L, T, and latex). Secondly, three evaporation methods were used to obtain EAERs: the direct heating method, low-temperature evaporation method, and improved evaporation method. Then, the high-temperature rheological parameters were determined using the Brookfield viscosity test, temperature-sweep test, and multiple stress creep recovery tests. Finally, microscopic test methods were adopted for the mechanism analysis, including the fourier transform infrared spectroscopy (FTIR) and the atomic force microscopy (AFM). The results show that different evaporation methods can significantly affect the high temperature performance evaluation results of EAERs. These differences are more obvious between high temperature evaporation and low temperature evaporation conditions. Moreover, the rutting resistance factor and phase angle of styrene-butadiene rubber (SBR) modified emulsified asphalt residues prepared by direct heating method present completely different change laws. From the FTIR and the AFM tests, it is found that these different change laws are due to the chemical reaction during the preparation of SBR modified emulsified asphalt residue by direct heating, which may be the aging of material or the degradation of polymer. In conclusion, the low-temperature evaporation method is recommended to prepare EAERs for a more realistic evaluation of the high-temperature performance of emulsified asphalt. The improved evaporation method should be prioritized as it further standardizes the parameters for subsequent laboratory testing.

Diffusion characteristics of surface treatment emulsion in aged asphalt mortar of porous asphalt mixture through SEM/EDS analysis

Short- and long-term mechanical performances of damaged porous asphalt mixture treated with asphalt emulsion

Study on Air-Purifying Performance of Semi-Flexible Asphalt Samples Coated with Titanium Dioxide Using Different Methods

Recovery efficiency of the damaged porous asphalt mixture with emulsion-based surface treatment: Material optimization and performance verification

Comparative Analysis of Rheological and Microscopic Performance of SBS Modified Asphalt Based on Field Aging and Laboratory Aging

Penetration Mechanism of the Emulsion-Based Rejuvenator in Damaged Porous Asphalt Mixture: Microstructure Characterization and 3D Reconstruction

Optimization Design of Asphalt Emulsion with Rejuvenator Towards a Uniform Distribution Inside the Damaged Porous Asphalt Mixture for a Better Ravelling Resistance

Investigation of the Microcharacteristics of Asphalt Mastics under Dry–Wet and Freeze–Thaw Cycles in a Coastal Salt Environment

Investigation on the stability and interaction of asphalt emulsion with waterborne acrylate as pavement maintenance coating

Characterization of the Drying Behaviour of Asphalt Emulsion

Investigation on Flowability and Microstructure of Fresh Cement Asphalt Binder

Use of MD Simulation for Investigating Diffusion Behaviors between Virgin Asphalt and Recycled Asphalt Mastic

A Study on the Microscopic Properties of the Oil–Stone Interfacial Phase of a Reclaimed Asphalt Mixture Based on Molecular Dynamics Simulation

Experimental measurements of the moisture diffusion and strength damage mechanism of dense asphalt mixtures

Research on High-Temperature Rheological Properties of Emulsified Asphalt Mastics and Their Influencing Factors

Assessment of testing methods for higher temperature performance of emulsified asphalt

Chemical, morphological and rheological investigations of SBR/SBS modified asphalt emulsions with waterborne acrylate and polyurethane

Investigation on the Wetting Behavior of Asphalt Emulsion on Aggregate for Asphalt Emulsion Mixture

Research on Performance Improvement of Emulsified Asphalt Mixture Based on Innovative Forming Process

Research on Water Stability and Moisture Damage Mechanism of a Steel Slag Porous Asphalt Mixture

Investigation on the oxidation aging resistance of asphalt by rejuvenator-loaded porous CaCO3 microparticles