Abstract:This paper outlines the design and testing process of the hull of a deep small Autonomous Underwater Vehicle (AUV), rated at 2000m depth. Many existing AUV pressure housings use aluminum or other isotropic traditional metals, instead of composites due to the complexities of the design of composites at such big load. The research at hand explains the process of design starting from setting the geometrical constraints for the design to mass production. To the best of the authors' knowledge, none of the previous studies has presented such detailed description of the work. Carbon fiber reinforced epoxy material was chosen thanks to its high strength-to-weight ratio and similarity of its compressibility to sea water. Material characterization was performed to obtain the material properties under loading conditions using a modified method of the Combined Loading Compression testing technique. A specific fixture was designed and manufactured to test filament-wound tubes. An analytical model was developed using MATLAB, a finite element model was created using ABAQUS, and the results of the two models were compared. A set of recommendations was introduced for the stacking sequence to provide the lowest possible stresses, regardless on the diving depth of the vehicle. Afterwards, a quality control set of tests was conducted, including seawater absorption under high pressure and void analysis using destructive and non-destructive tests. Pilot samples were manufactured and tested in a pressure vessel, where it was cycle-tested and inspected using visual and ultrasonic testing. Other samples were fail-tested and showed a failure at ~93% of the expected failure load. Such range can be considered good to provide safe operation for the vehicle at the designated depth, given that the factor of safety included covers more than 7% of the failure load. The proposed design methodology has shown that CFRE can be- safely used even at such high depths.

Design of the Compressive Instrument Cabin Used in Deep Sea

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

FEA-Based Failure Analysis of a UHP Chamber for Simulation of Deep Sea Conditions

A New Deep-Sea Gas-Tight Isobaric Water Sampler

A Film-Type Pressure Self-Adaptive Watertight Junction Box in Deep-Sea Equipment

Structural Design and Strength Analysis on Framework for Deep Sea Manned Submersible

Measurement and control system for gas-tight deep-sea water sampler based on LabVIEW

Design and Simulation Analysis of a 120 MPa Deep-Sea Ultra-High Pressure Environment Simulation Test Chamber

A Capacitive Pressure Sensor with Adjustable Working Range for Deep Sea

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Study on the Pressure Retention Characteristic of a New Isobaric Water Sampler

Sealing Performance Analysis of Deep-Sea Sediment Sampler

Study of an Underwater retrievable cabin manufactured by hand layup process

Design and application of stratified gastight system for acquiring water sample in deep-sea

A New Isobaric Water Sampler with the Function of Adaptive Recompression

A Deep-Sea Sediment Sampling System: Design, Analysis and Experimental Verification

Design and Testing of a Composite Pressure Hull for Deep Autonomous Underwater Vehicles

Investigation of the 3D-DIC testing method for composite shell in a deep-water high-pressure environment

Mechanical Design of Scientific Instrument Interface Module in Cabled Seafloor Observatory

Research and Analysis of Pressure-Maintaining Trapping Instrument for Macro-Organisms in Hadal Trenches