Abstract:This paper outlines the design and testing process of the hull of a deep small Autonomous Underwater Vehicle (AUV), rated at 2000m depth. Many existing AUV pressure housings use aluminum or other isotropic traditional metals, instead of composites due to the complexities of the design of composites at such big load. The research at hand explains the process of design starting from setting the geometrical constraints for the design to mass production. To the best of the authors' knowledge, none of the previous studies has presented such detailed description of the work. Carbon fiber reinforced epoxy material was chosen thanks to its high strength-to-weight ratio and similarity of its compressibility to sea water. Material characterization was performed to obtain the material properties under loading conditions using a modified method of the Combined Loading Compression testing technique. A specific fixture was designed and manufactured to test filament-wound tubes. An analytical model was developed using MATLAB, a finite element model was created using ABAQUS, and the results of the two models were compared. A set of recommendations was introduced for the stacking sequence to provide the lowest possible stresses, regardless on the diving depth of the vehicle. Afterwards, a quality control set of tests was conducted, including seawater absorption under high pressure and void analysis using destructive and non-destructive tests. Pilot samples were manufactured and tested in a pressure vessel, where it was cycle-tested and inspected using visual and ultrasonic testing. Other samples were fail-tested and showed a failure at ~93% of the expected failure load. Such range can be considered good to provide safe operation for the vehicle at the designated depth, given that the factor of safety included covers more than 7% of the failure load. The proposed design methodology has shown that CFRE can be- safely used even at such high depths.

Study of an Underwater retrievable cabin manufactured by hand layup process

Development of an AUV “Xuanwu-1” with Docking Function

Numerical Simulation on the Deploying and Recovering Process for A Node of Underwater Wireless Sensor Network

Structural Design and Strength Analysis on Framework for Deep Sea Manned Submersible

A Deep-Sea Large-Volume High-Pressure Simulation System—design, Analysis and Experimental Verification

Development and Test of a Subsea Docking System Applied to an Autonomous Underwater Helicopter

Design and Performance Analysis of a Pressure Chamber for Simulation of Deep Sea Conditions

Development and Mechanical Characterization of HGMS–EHS-Reinforced Hollow Glass Bead Composites

Lifetime assessment of deep-sea manned cabin with PMMA pressure-resistant hull prior to micro-cracks

Design and Testing of a Composite Pressure Hull for Deep Autonomous Underwater Vehicles

Experimental investigation of the hydrostatic compression of a hollow glass microspheres/epoxy resin under high‐pressure conditions at the full ocean depth

Test and numerical analysis for water entry of elastic cabin from amphibious aircraft

Design of the Compressive Instrument Cabin Used in Deep Sea

An underwater docking system based on UUV and recovery mother ship: design and experiment

Failure process analysis of frustum windows for deep-sea manned cabin

Design of Underwater Glider Experimental Prototype

Numerical Simulation Study on the Recovery Process of Autonomous Underwater Vehicle

Underwater Glider Design Based on Dynamic Model Analysis and Prototype Development.

Domestic and Foreign Development of Manned Submersibles with Transparent Pressure Hull

Time-dependent axial displacement of PMMA frustums designed for deep-sea manned cabin based on finite element analysis

Design and analysis of the self-elevating double submerged buoy measurement system