Abstract:<p>As it is usually operating in bad working conditions and subjected to the severe interference from diverse paths, internal faults of the hydraulic valve are difficult to be detected using conventional hydraulic testing technology (such as relying on pressure sensors or flow sensors). Moreover, the information collected from a single sensor may not provide accurate diagnostic evidence or a complete description on faults of hydraulic valves, even though employing intelligent fault diagnosis methods. Therefore, a two-stage multi-sensor information fusion method is proposed, including the fault feature fusion and the decision-making information fusion. The aim is to realize the diagnosis on internal faults of hydraulic directional valves using the vibration signal analysis method instead of conventional hydraulic testing ones. The method is mainly divided into three steps. First, the noise reduction of the vibration information collected by multiple acceleration sensors is done using ensemble empirical mode decomposition (EEMD) and Teager-Kaiser energy operator (TEO), so that fault features are more obvious. Then, multi-class fault features including the severity and the location of the wear are extracted from the preprocessing signals to form the original feature set. Second, combined with feature ranking and subset selection based on euclidean distance (FRSSED) and maximum relevance minimum redundancy (mRMR) feature selection method, the statistical features extracted from multiple sensor signals are optimized to form the optimal feature subset. This is the first-level information fusion concerned with fault feature information fusion. In the third step, based on Dempster-Shafer (DS) evidence theory and convolutional neural network (CNN), decision-making information is fused (called second-level information fusion) to obtain the final diagnosis results. A hydraulic test bench is built to test different failure valves. Experimental results indicate that this method is effective in extracting the fault features from multi-sensor signals and detecting the fault states including severity and location of internal wear of the hydraulic valve.</p>

Fault feature extraction method for AUV thruster based on two-stage fusion from multi-source information

A Transferable Thruster Fault Diagnosis Approach for Autonomous Underwater Vehicle under Different Working Conditions with Insufficient Labeled Training Data

A New Procedure for Extracting Fault Feature of Multi-Frequency Signal from Rotating Machinery

Feature Extraction Of Impulse Faults For Vibration Signals Based On Sparse Non-Negative Tensor Factorization

Attention mechanism‐based multisensor data fusion neural network for fault diagnosis of autonomous underwater vehicles

Unsupervised fault diagnosis framework for underwater thruster system using estimated torques and multi-head convolutional autoencoder

Weak Fault Feature Extraction and Enhancement of Autonomous Underwater Vehicle Thrusters Based on Artificial Rabbits Optimization and Variational Mode Decomposition

Data and Model Combined Unsupervised Fault Detection and Assessment Framework for Underwater Thruster

Fault Diagnosis Based On Fusion Of Multi-Channel Observations By Sensors With Independent Component Analysis And Mutual Information

Bearing fault diagnosis method based on multi-source heterogeneous information fusion

Model-free Fault Diagnosis for Autonomous Underwater Vehicles Using Sequence Convolutional Neural Network

Fault diagnosis in a hydraulic directional valve using a two-stage multi-sensor information fusion

Temporal-Spatial Attention Network: A Novel Axial Piston Pump Coupled Fault Diagnosis Method

Bearing Fault Feature Extraction and Fault Diagnosis Method Based on Feature Fusion

The Fusiongram: A Periodic Weak Fault Feature Extraction Strategy and Its Application in Bearing Fault Diagnosis

Navigation Multisensor Fault Diagnosis Approach for an Unmanned Surface Vessel Adopted Particle-Filter Method

A High-Dimensional and Small-Sample Submersible Fault Detection Method Based on Feature Selection and Data Augmentation

A Model-Driven Approach to Extract Multi-Source Fault Features of a Screw Pump

Gearbox fault diagnosis based on RGT-MFFIN and multi-sensor fusion image generation

A two-stage sound-vibration signal fusion method for weak fault detection in rolling bearing systems

A feature sample screening and local outlier factor fusion method for detecting tidal stream turbine blade impact fault