Abstract:Aiming to evaluate the serviceability performance of bridge piers after potential terrorist attacks or accidental explosions, the residual seismic performance of post-blast reinforced concrete (RC) piers was studied by performing the test and numerical simulation. Firstly, the field explosion and successive lateral cyclic loading tests were performed on two 1/2-scale RC piers, and a single lateral cyclic loading test was performed on two intact control piers for comparison. The test data such as the incident overpressure-time histories, as well as the damage profiles, hysteretic curves and skeleton curves of piers, etc. were obtained and fully discussed. Then, an integrated finite element (FE) analysis approach based on the explicit–implicit switching algorithm was proposed to reproduce the dynamic and quasi-static responses of RC piers under blast and successive lateral cyclic loadings. Furthermore, four commonly used concrete material models were systematically compared and evaluated based on the basic mechanical property, explosion, and lateral cyclic loading tests. Finally, by comparing with the test data, the applicability of concrete material models and corresponding parameters, as well as the proposed integrated FE analysis approach for the residual seismic performance analysis of post-blast RC piers were verified comprehensively. It is concluded that: (i) after 0.5 kg TNT explosion, the positive yield and peak forces obtained from the lateral cyclic loading test are close to those of the intact control piers, whereas the negative yield and peak forces decrease to 66 % and 70 % of the intact ones; (ii) after 1.0 kg TNT explosion, the positive yield and peak forces are 77 % and 81 % of the intact values, while the negative yield and peak forces are only 37 % and 42 % of the intact ones; (iii) by replacing the explicit algorithm with implicit algorithm during the residual seismic performance analysis, the computational cost is saved by about 70 times; (iv) Winfrith concrete model can better predict the residual seismic performance of post-blast RC piers, with the deviations limited in 20 %. The present work can provide a reference for the designer and researchers in evaluating the seismic performance of the post-blast RC bridge piers during the whole service life.

Estimating Seismic Response of RC Piers under Unidirectional and Bidirectional Shaking: A Mechanics-Based Approach

Static Shear Performance and Residual Axial Capacity of Rectangular RC Bridge Piers under Near-Ground Lateral Loads

Stochastic seismic responses analysis of long-span rigid-framed bridge with high piers considering travelling wave effect

A Parametric Investigation on Ultra-low Cycle Fatigue Damage of Steel Bridge Piers under Horizontal Bi-directional Seismic Excitations

Machine Learning-based Seismic Fragility Curves for RC Bridge Piers

Effectiveness of CFRP Seismic-Retrofit of Circular RC Bridge Piers under Vehicular Lateral Impact Loading

Response of Structures to Bidirectional Seismic Loading: Research Progress and Future Directions

Reliability assessment and sensitivity analysis of vehicle impacted reinforced concrete circular bridge piers

Estimating structural response to bidirectional seismic excitation using spectrum compatible motions: Performance of a pair of companion spectra

3D response simulation of a bridge with a posttensioned base rocking steel pier under sequential loading of traffic loads, braking force, and earthquake excitations

Damage assessment of circular bridge pier incorporating high-strength steel reinforcement under near-fault ground motions

Lateral Cyclic Response Sensitivity of Rectangular Bridge Piers Confined with UHPFRC Tube Using Fractional Factorial Design

Experimental and numerical study on the residual seismic performance of post-blast RC piers

Improvement of energy damage index bounds for circular reinforced concrete bridge piers under dynamic analysis

Seismic Analysis Of Rectangular Hollow Section Rc Piers Including Flexure-Shear Coupling Behavior

A Physics-Informed Neural Network for the Nonlinear Damage Identification in a Reinforced Concrete Bridge Pier Using Seismic Responses

Estimation of inelastic displacement ratio spectrum for existing RC structures via displacement response spectrum

An approach to seismic damage detection and evaluation in RC bridge piers through vibration data

Rapid post-earthquake damage assessment of ageing reinforced concrete bridge piers using time-frequency analysis

Damage characterization and resilience optimization of reinforced concrete bridge piers under vehicle impact

Fiber-based damage analysis of reinforced concrete bridge piers