Bifunctional low-Pt content nanocatalysts supported on carbons functionalized with a Cu-organometallic compound: Tailoring of d-band center with high catalytic activity for electrochemical oxygen reactions

M.O. Fuentez-Torres,F.J. Rodríguez-Varela,M.E. Sánchez-Castro,B. Escobar-Morales,W.J. Pech-Rodríguez,I.L. Alonso-Lemus
DOI: https://doi.org/10.1016/j.ijhydene.2024.03.059
IF: 7.2
2024-03-18
International Journal of Hydrogen Energy
Abstract:In this study, Vulcan XC-72 (C) and sewage sludge-derived biocarbon (SSB) are functionalized with mesitylcopper (Cu-mes) and implemented to produce the low-Pt content and thus low-cost (5 wt %) Pt/C Cu-mes10 , Pt/C Cu-mes20 , Pt/SSB Cu-mes10 , and Pt/SSB Cu-mes20 nanocatalysts. This approach facilitates the generation of various functional groups along with the CuO and Cu 2 O phases. The nanocatalysts show the formation of the PtCu 3 alloy, with the two first having an atomic fraction of Cu alloyed (X Cu ) of 55 and 67%, respectively. Pt/C Cu-mes10 shows a comparable catalytic activity for the oxygen reduction reaction (ORR) before and after an accelerated degradation test (ADT) to 20 wt % Pt/C and 5 wt % Pt/C. It also shows the highest performance for the oxygen evolution reaction (OER), with remarkable electrochemical stability. The outstanding performance of Pt/C Cu-mes10 is attributed to the presence of Cu-phases, its high degree of alloying and its d-band center which favorably promotes the adsorption of O-species and their further reaction. Specifically, the PtCu 3 alloy promotes the kinetics of the reactions by modulating the electronic properties of Pt and creating dual active sites. Meanwhile, Pt/SSB demonstrates an encouraging performance for the reactions before ADT, with electrochemical parameters similar to those of 20 wt % Pt/C. However, its stability is poor, with low catalytic activity after ADT. Therefore, it is found that there is a significant effect of the electrochemical behavior of the carbon support on the performance and stability of the nanocatalysts. The potential application of Pt/C Cu-mes10 in water splitting devices is identified.
energy & fuels,electrochemistry,chemistry, physical
What problem does this paper attempt to address?