Abstract:The reasons for such violations are various: aging of insulation, breakages of wires of overhead transmission lines, mechanical damages of isolation of cable lines at ground works, lightning strikes in the transmission line and others. Most often, short-circuits occur through transient resistance, such as through the resistance of an electric arc that occurs at the point of damage to the insulation. Sometimes there are metallic short circuits in which the resistance of the electric arc is very small. The study of short circuits in the power grid is a major step in the design of modern electrical networks. The research is conducted using computer software, first by modeling the system and then simulating errors. A malfunction usually leads to an increase in the current flowing in the lines, and failure to provide reliable protection can result in damage to the power unit. Thus, short-circuit calculations are the primary consideration when designing, upgrading, or expanding a power system. The three-phase short circuit is the least likely. However, in many cases, the three-phase short circuit is associated with the most severe consequences, as it causes the highest power imbalances on the shafts of the generators. The study of transients begins with the mode of three-phase closure due to its relative simplicity in comparison with other types of asymmetry. In most cases, the analysis and calculation of the transient regime of the electrical system involves the preparation of a calculated scheme of substitution, in which the parameters of its elements are determined in named or relative units. The electrical substitution circuitry is used to further study the transients in the power system. The definition of electrical and electromagnetic quantities in relative units is widely used in the theory of electric machines. This is because it significantly simplifies the theoretical calculations and gives the results a generalized view in the practical calculations of currents and residual voltages at the short circuit. By the relative value of any value is understood as its relation to another value of the same name, taken as the base. So, before presenting any quantities in relative units, we need to choose the basic units. In the electrical system with increased voltages, the overall load capacity of the network increases, which in turn makes it possible to supply high-quality electrical energy over a greater distance. In the process of comparing the type of transmission lines, it should be noted that the advantages of the cable transmission line. According to the results of the calculation of short-circuit currents, it can be concluded that in networks with a larger line cross-section and a higher voltage, the short-circuit currents are larger. Thus, during the transition of the electric networks to the higher voltage class of 20 kV, the currents of the KZ increased by 43% compared to the 6 kV electric network. This analysis shows that the importance of reliable power supply in the power supply system for high voltage classes must be high and have equipment to prevent emergencies. In the future, it is planned to develop a systematic calculation of short-circuit currents for a number of transmission lines and to conduct mathematical modeling in the system of applications for the study of transient processes at short circuits

Current State and Prospects of Development of Gas-Insulated Power-Transmission Lines and Busbars at 110–1100 kV

Experimental Research on Hot-line Work of 750 Kv Single Compact Power Transmission Line

Research Status and Prospect of Gas-insulated Metal Enclosed Transmission Line

Thermal control of conductors

Advanced Dielectrics for Gas-Insulated Transmission Lines [Editorial]

Research progress on environmental-friendly insulating gases for HVDC gas-insulated transmission lines

Types of overvoltages in 10-35 kV distribution networks and modern methods and means of their limitation

Gas-insulated transmission lines state classification and fault chamber location based on the divergence characteristics of temperature parameters

DISCUSSION ON SEVERAL IMPORTANT PROBLEMS OF DEVELOPING UHV AC TRANSMISSON IN CHINA

Line electrical transmission damage identification tool in distributors electrical networks

Technical aspects of gas insulated transmission lines and application of new insulating gases

Characteristics of Three Kinds of Insulators and Their Applications Evaluation at Them in UHV Transmission Lines

Partial discharge detection and diagnosis in gas insulated switchgear: State of the art

Characteristic of Power-transmission-induced Current and Power Loss on the OPGW of 750 kV Transmission Line System

Conceptual Design and Feasibility Study of Flexible Gas-Insulated Transmission Line Using CF3I Gas Mixture

Transient Overvoltage Simulation Analysis of 1100kV Long Distance GIL

Development of a thermal model of a bus conductor with polymer-gas insulation for power transmission of offshore wind turns

Short circuits currents comparison of 6 (10) kV and 20 kV.

On the issue of applying the dynamic thermal rating in electric power distribution system

Accident analysis of 220, 500 kV overhead lines of the main power systems network

Analysis of Induced Voltage of Ground Wires in 1000kv Transmission Lines