Abstract:In recent years, the X-ray interferometer using dual phase gratings has been extensively studied. The large periodic fringes produced by the X-ray interferometer using dual phase gratings can be directly detected by ordinary detectors. At the same time, the X-ray interferometer using dual phase gratings can reduce the radiation dose of the sample without using absorption gratings. Meanwhile, a high fringe visibility is always preferred to achieve a high signal-to-noise ratio for X-ray grating interferometry. However, recent studies have reported that experimental fringe visibility in X-ray interferometer using dual rectangular phase gratings is relatively low. Therefore, it is necessary to further increase the fringe visibility in X-ray interferometry using dual phase gratings. This work focuses on the analysis of fringe visibility in X-ray interferometer using dual triangular phase gratings. Based on the fringe intensity distribution formula of X-ray dual phase grating interferometer, the fringe visibility of the dual triangular phase grating interferometer is investigated as a function of the grating spacing under monochromatic and polychromatic illumination, respectively. For comparison, the fringe visibility of the dual rectangular phase grating interferometer is also studied under the same condition. The results show that the maximum fringe visibility of the dual triangular phase grating interferometer increases with the phase shift increasing regardless of monochromatic or polychromatic illumination. Under monochromatic illumination, the maximum fringe visibility of dual 5 & pi;/2 triangular phase gratings is about 21% higher than that of dual rectangular phase gratings. Under polychromatic illumination, the fringe visibility of dual 5 & pi;/2 triangular phase gratings is at least 23% higher than that of dual rectangular phase gratings. Under polychromatic illumination, the greater the deviation of X-ray average energy from the grating design energy, the greater the decrease of maximum fringe visibility of the dual phase grating interferometer is. In addition, with the increase of the focal size of X-ray source, the maximum fringe visibility of the dual phase grating interferometer decreases, under polychromatic illumination. We hope that those results can be used as guidelines for designing and optimizing X-ray interferometer using dual triangular phase gratings.

Two-dimensional binary phase gratings for zero-order and high-order diffraction suppression

Diffraction Properties of Transmission Binary Blazed Grating

Design of Large-Deflection-angle High-Diffraction-efficiency High-Dispersion Hybrid Gratings

Binary Approximate Structure of Blazed Grating

Phase-Type Quantum-Dot-Array Diffraction Grating

Binary Sub-Wavelength Grating with Dynamic Sub-Period

Phase-dithered Waveguide Grating with Flat Passband and Sharp Transitions

Simulating And Optimizing For The Phase Depth Of The Multilevel Grating

Diffractive grating of high efficiency produced by binary optics

Design and fabrication of soft-x-ray transmission phase gratings

Design and Analysis of Concave Diffraction Grating with One-Dimensional Photonic Bandgap Structure

Dual-wavelength terahertz two-dimensional phase gratings based on all dielectric metasurfaces

Polarization-independent and high-efficiency 2D dielectric transmission grating under Littrow incidence

Design of New Type of Isosceles Blazed Grating

Interference Lithography Based on a Phase Mask for the Fabrication of Diffraction Gratings

Two-port Reflective Grating with the Cancellation of the Zeroth Order

Polarization-independent grating with the zeroth order suppressed

Efficient Bragg Diffraction in Thin Semiconductor Two-Dimensional Gratings.

Optimized Design Of Phase Gratings And Analysis Of Diffractive Efficiency

Achromatic Quarterwave-Plate for Visible Spectrum Region Using the Dispersion of Form Birefringence

Fringe Visibility in X-ray Interferometer Using Dual Triangular Phase Gratings