Abstract:The physical properties of shale reservoirs are typically poor, necessitating the use of fracturing technology for effective development. However, the high clay content prevalent in shale formations poses significant challenges for conventional hydraulic fracturing methods. To address this issue, CO2-based fracturing fluid has been proposed as an alternative to mitigate the damage caused by water-based fracturing fluids. In this paper, the applicability of quasi-dry CO2 fracturing in shale reservoirs is examined from three key perspectives: the viscosity of CO2 fracturing fluid, the fracture characteristics induced by the CO2 fracture fluid, and the potential reservoir damage caused by the fracturing fluid. Firstly, the viscosity of CO2 fracturing fluid was determined by a rheological experiment. Rheological tests revealed that the viscosity of CO2 fracturing fluid was significantly influenced by the water–carbon ratio. Specifically, when the water–carbon ratio was 30:70, the maximum viscosity observed could reach 104 mPa·s. Moreover, increasing reservoir temperature resulted in decreased fracturing fluid viscosity, with a 40 °C temperature rise causing a 20% viscosity reduction. Secondly, matrix permeability tests were conducted to investigate permeability alteration during CO2 fracturing fluid invasion. Due to the weak acidity of CO2-based fracturing fluid, the permeability reduction induced by clay hydration was inhibited, and an increase in permeability was observed after a 3-day duration. However, the matrix permeability tends to decrease as the interaction time is prolonged, which means prolonged soaking time can still cause formation damage. Finally, triaxial fracturing experiments facilitated by a three-axis servo pressure device were conducted. The fracture properties were characterized using computed tomography (CT), and 3D reconstruction of fractured samples was conducted based on the CT data. The results demonstrate that CO2 fracturing fluid effectively activates weak cementation surfaces in the rock, promoting the formation of larger and more complex fractures. Hence, CO2 quasi-dry fracturing technology emerges as a method with significant potential, capable of efficiently stimulating shale reservoirs, although a reasonable soaking time is necessary to maximize hydrocarbon production.

Investigation of creep and transport mechanisms of CO 2 fracturing within natural gas hydrates

Formation Kinetics and Morphology Characteristics of Fracture-Filling Natural Gas Hydrate under the Influence of Multiple Parameters

Numerical analysis of the production behaviors and geomechanical responses during natural gas hydrate production by vertical wells fracturing

Gas Production Enhancement by Horizontal Wells with Hydraulic Fractures in a Natural Gas Hydrate Reservoir: A Thermo-Hydro-Chemical Study

Role of Mechanical Deformation in the Thermal Transport of Si-Type Methane Hydrate.

Evaluation of the gas production enhancement effect of hydraulic fracturing on combining depressurization with thermal stimulation from challenging ocean hydrate reservoirs

Time-dependent deformation of marine gas hydrate-bearing strata conditioned to a wellbore: Experiments and implications

A hydrate reservoir renovation device and its application in nitrogen bubble fracturing

Production Simulation of Stimulated Reservoir Volume in Gas Hydrate Formation with Three-Dimensional Embedded Discrete Fracture Model

Analysis of Reservoir Stability During Natural Gas Hydrate Exploitation under Incline Seafloor

Numerical Simulation of Hydraulic Fracture Characteristics in Gas Hydrate Bearing-Sediments by Using CDEM

Molecular Dynamics Study on Mechanical Properties of CO 2 –N 2 Heteroclathrate Hydrates

Molecular Dynamics Study on Mechanical Properties of CO2–N2 Heteroclathrate Hydrates

Exploration of Production Capacity-Geomechanical Evaluation and CO2 Reinjection Repair Strategy in Natural Gas Hydrate Production by Multilateral Horizontal Wells

2D Numerical Simulation of Hydraulic Fracturing in Hydrate-Bearing Sediments Based on the Cohesive Element

Enhanced gas production efficiency of class 1,2,3 hydrate reservoirs using hydraulic fracturing technique

Thermo-hydro-chemical modeling and analysis of methane extraction from fractured gas hydrate-bearing sediments

Investigating the Interaction Effects between Reservoir Deformation and Hydrate Dissociation in Hydrate-Bearing Sediment by Depressurization Method

The Effects of the Length and Conductivity of Artificial Fracture on Gas Production from a Class 3 Hydrate Reservoir

Further Investigation of CO2 Quasi-Dry Fracturing in Shale Reservoirs—An Experimental Study

Research on Hydrate Formation Rules in the Formations for Liquid CO2 Fracturing