Abstract:Thermo-acoustic tomography is a non-invasive medical imaging technique, constituting a precise and cheap alternative to X-imaging. The principle is to excite a body to reconstruct with a pulse inducing an inhomogeneous heating and therefore expansion of tissues. This creates an acoustic wave pressure which is measured with sensors. The reconstruction of heterogeneities inside the body can be then performed by solving an inverse problem, knowing measurements of the acoustic waves outside the body. As the intensity of the measured pressure is expected to be small, a challenging problem consists in locating the sensors in a adequate way. This paper is devoted to the determination of an optimal sensors location to achieve this reconstruction. We first introduce a model involving a least square functional standing for an observation of the pressure for a first series of measures by sensors, and an observability-like constant functional describing for the quality of reconstruction. Then, we determine an appropriate location of sensors for two series of measures, in two steps: first, we reconstruct possible initial data by solving a worst-case design like problem. Second, we determine from the knowledge of these initial conditions the optimal location of sensors for observing in the best way the corresponding solution of the wave equation. Far from providing an intrinsic solution to the general issue of locating sensors, solving this problem allows to determine a new sensors location improving the quality of reconstruction before getting a new series of measures. We perform a mathematical analysis of this model: in particular we investigate existence issues and introduce a numerical algorithm to solve it. Eventually, several numerical 2D simulations illustrate our approach.

Determination of the sound speed and an initial source in photoacoustic tomography

Time reversal method for thermoacoustic acoustic tomography in elastic media: convergence with sharp observation time

Enhancement of Photoacoustic Tomography in the Tissue with Speed-of-sound Variance Using Ultrasound Computed Tomography

An Inverse Hyperbolic Problem with Application to Joint Photoacoustic Parameter Determination

Photoacoustic computed tomography for joint reconstruction of initial pressure and sound speed in vivo using a feature coupling method

Photoacoustic Tomography With Spatially Varying Compressibility and Density

Simultaneous reconstruction of the initial pressure and sound speed in photoacoustic tomography using a deep-learning approach

Implicit learning to determine variable sound speed and the reconstruction operator in photoacoustic tomography

Quantitative Photo-acoustic Tomography with Partial Data

Piecewise Acoustic Source Imaging with Unknown Speed of Sound Using a Level-Set Method

Automatic Speed Of Sound Correction With Photoacoustic Image Reconstruction

Feature Coupling Photoacoustic Computed Tomography for Joint Reconstruction of Initial Pressure and Sound Speed in Vivo

Numerical Investigation of Nonlinear Sound Propagation of Photoacoustic Tomography Imaging.

Variational Iterative Algorithms in Photoacoustic Tomography with Variable Sound Speed

How locating sensors in thermo-acoustic tomography?

Recovery of an inclusion in Photoacoustic imaging

Joint reconstruction of the initial pressure and speed of sound distributions from combined photoacoustic and ultrasound tomography measurements

Inverse Transport Theory of Photoacoustics

Simultaneous Reconstruction of Acoustic and Optical Properties of Heterogeneous Media by Quantitative Photoacoustic Tomography

Light Focusing and Two-Dimensional Imaging Through Scattering Media using the Photoacoustic Transmission-Matrix with an Ultrasound Array

Photoacoustic Tomography Extracted from Speckle Noise in Acoustically Inhomogeneous Tissue.