Abstract:Conventional solid-state photodetectors, such as those made using silicon, are typically diode structures operated with a reverse bias placed across them. Low dark currents result; carriers photo-generated in the depletion region form a drift current which is the basis for light detection. Light with an energy greater than the band gap of the material can be seen. Silicon has a 1.1 eV band gap and devices fabricated from this material therefore react to both ultra-violet and visible wavelengths. The high resistivity of diamond suggests that diode structures may not be needed to achieve low dark currents if this material were used for the fabrication of photodetectors. Metal/diamond/metal devices can be considered which simply rely upon photoconductivity for their operation; such a device could possess high gain, since many carriers may be able to flow around the detector circuit during the lifetime of a photo-generated electron-hole pair. The wide band gap (5.5 eV, 225 run) of diamond implies that this form of photodetector will be capable of detecting deep UV light while being essentially “blind” to visible wavelengths. This property is highly desirable; filtering conventional devices to make them visible blind significantly reduces their sensitivity to UV light. The physical and chemical robustness of diamond also suggests that such devices may be suitable for operation in hostile environments. Diamond can exhibit high carrier mobilities, saturated carrier velocities and electric field breakdown strength; these properties suggest that fast detectors may be realisable. Many industrial, military and environmental applications can thus be envisaged for diamond UV sensors. The emergence of commercially accessible thin-film diamond grown by chemical vapour deposition (CVD) has enabled reliable devices to be developed. In this chapter, the intrinsic and extrinsic photoconductivity of thin-film diamond is reviewed; the design, fabrication and performance of diamond UV photodetectors is then discussed, along with some of the uses for these devices. For some applications, it may be desirable to fabricate diamond photodiodes; the realisation of this type of device from p-type material is also addressed.

Diamond Detectors for UV and X-Ray Source Imaging

Mosaic diamond detectors for fast neutrons and large ionizing radiation fields

An X-ray beam profile monitoring system at a beamline front-end combining a single-crystal diamond film and energy discrimination using droplet analysis

A polycrystalline diamond micro-detector for X-ray absorption fine-structure measurements

Monocrystalline diamond detector for online monitoring during synchrotron microbeam radiotherapy

CVD Diamond for Ultraviolet and Particle Detectors

A readout system for highly sensitive diamond detectors for FLASH dosimetry

A Diamond-Based Dose-per-Pulse X-ray Detector for Radiation Therapy

A multi-electrode two-dimensional position sensitive diamond detector

Recent Advances in Diamond Detectors

Development of a Triple-GEM detector with strip readout and GEMINI chip for X rays and neutron imaging

A study of particle detectors based on single crystal diamond substrate

The Design of Diamond Compton Telescope

Self-powered solar-blind ultrafast UV-C diamond detectors with asymmetric Schottky contacts

Characterization of a single crystal diamond pixel detector in a high energy particle beam

Characterization of CVD diamond detector with FLASH electron beam from modified LINAC accelerator

Recent progress in diamond radiation detectors

A Highly Versatile X-ray and Electron Beam Diamond Dosimeter for Radiation Therapy and Protection

Calibration of diamond detectors for dosimetry in beam-loss monitoring

Diamond sensors for hard X-ray energy and position resolving measurements at the European XFEL

Design, realization, and characterization of a novel diamond detector prototype for FLASH radiotherapy dosimetry