Abstract:The incidence angle effect causes a decrease in the photogenerated current of photovoltaic (PV) modules when they are subject to incident irradiance at wide angles: Its quantification is challenging and particularly relevant for novel integrated PV applications. This work reports the results of an international interlaboratory comparison conducted within a project team that is currently working at the new edition of the dedicated IEC standard with novel reproducible measurement techniques. The incidence angle effect causes a decrease in the photogenerated current of PV modules when they are subject to incident irradiance at wide angles: Its relevance should be quantified for accurate energy yield purposes and has recently gained significance due to the rising interest in novel integrated PV applications, where vertical or nonoptimal tilt are favored (e.g., in urban structures, in agrivoltaics, and vehicles). The international standard IEC 61853‐2 presents both outdoor and indoor measurement methods: However, the indoor measurement method for commercial‐size modules is often impractical due to irradiance uniformity limitations on the volume spanned by the tested module upon rotation in most of the solar simulators available on the market. In recent years, new solutions have been proposed to overcome these limitations and allow wider adoption of this standard: However, method validations and interlaboratory comparisons have been conducted so far only on small‐area samples, and a real validation on commercial‐size modules is still missing. In this work, we aim at filling this gap, reporting the results of an interlaboratory comparison conducted within the international project team that is currently working at the new edition of IEC 61853‐2. The results show a remarkable agreement between different measurement methods, thus validating more options for the evaluation of this important effect.

Enhanced Photovoltaic Panel Diagnostics: Advancing a High-Precision and Low-Cost I – V Curve Tracer

Design of a Portable Low-Cost I-V Curve Tracer for On-Line and In Situ Inspection of PV Modules

Design and Development of a New Smart Portable I-V Tracer

Low-Cost I–V Tracer for PV Fault Diagnosis Using Single-Diode Model Parameters and I–V Curve Characteristics

Identifying PV Module Mismatch Faults by a Thermography-Based Temperature Distribution Analysis

Configurable IoT Open-Source Hardware and Software I-V Curve Tracer for Photovoltaic Generators

A Fast MPPT-based Anomaly Detection and Accurate Fault Diagnosis Technique for PV Arrays

A Robust Parametrization Method of Photovoltaic Modules for Enhancing One-Diode Model Accuracy under Varying Operating Conditions

Low-cost infrared thermography in aid of photovoltaic panels degradation research

Research of Volt-Ampere Characteristics Testing Method for Photovoltaic Cells

Defect Detection and Degradation Analysis in Photovoltaic Modules Using Thermography, Spectroscopy, and Current–Voltage Measurements, and Quantitative Assessment of Their Impact

In-Situ Measurement of Power Loss for Crystalline Silicon Modules Undergoing Thermal Cycling and Mechanical Loading Stress Testing

A New Photovoltaic Emulator Designed for Testing Low-Power Inverters Connected to the LV Grid

Photovoltaic Modeling: A Comprehensive Analysis of the I–V Characteristic Curve

Quantitative Comparison of Infrared Thermography, Visual Inspection, and Electrical Analysis Techniques on Photovoltaic Modules: A Case Study

Solar Panels String Predictive and Parametric Fault Diagnosis Using Low-Cost Sensors

A New High-Performance Photovoltaic Emulator Suitable for Simulating and Validating Maximum Power Point Tracking Controllers

A series resistance extraction method for health evaluation of photovoltaic modules

Fault Diagnosis in a Photovoltaic Array Using I-V Characteristics Analysis with Experimental Validation

Inexpensive Current-Voltage System with Electronically-Controlled Resistance under Xenon Arc Light for Solar Cell Efficiency Measurements

Incidence Angle Effect: Validation of New Measurement Methods for IEC 61853‐2