Abstract:The new concept of sewer mining which utilizes the ceramic nanofiltration (C-NF) membranes offers a compact solution for water and other resources recovery. However, since it has very limited pre-treatment process, membrane fouling is a common problem due to the direct contact between the membrane and sewage water. Sewage water contains a lot of extracellular polymeric substances (EPS) that can block the membrane pores. One of the most persistent EPS is sodium alginate which responsible for the gel layer formation on the membrane surface. Removal of the alginate gel layer can be done by implementing chemical cleaning. However, too frequent chemical cleaning can damage the membrane and environmentally dangerous. Therefore, to make this new concept of sewer mining more feasible, the correct cleaning method to remove the fouling layer need to be found. From this point, the research objective for this research is formulated as “Investigation of fouling control methods that can prolong the time before chemical cleaning needs to be performed to achieve higher water production.” Several methods such as forward flush, iron coating and calcium carbonate coating were investigated. Alginate filtration was done under constant pressure experiment and the effectivity of each cleaning method was calculated by measuring the change in water permeability after the cleaning. The results show that the iron and calcium carbonate coating followed by 5 min forward flush are able to achieve a permeability recovery of 40 to 90 %. Iron coating required 400 mg/l of iron hydroxide to be dossed and a minimum of 5 min reaction times with hydrogen peroxide to have a high permeability recovery. On the other hand, only 1 minute is required by 200 mg/l calcium carbonate dosing concentration with citric acid as a cleaning solution to achieve a similar improvement as the iron hydroxide coating. Both of the processes produce higher water productivity in 2 h of experiment than the chemical cleaning with 0.1 % sodium hypochlorite. In the end, a theoretical projection on the real sewage water filtration was made to study the economic and environmental impact of the coating process. The results show the cost of production per m3 of clean water is 0.22 euro for iron hydroxide and only 0.12 euro for calcium carbonate. Furthermore, environmental impact assessment using Chain Management by Life Cycle Analysis (CMLCA) software which produced by Leiden University with Eco-indicator 99 (EI-99) categorization shows that calcium carbonate has less environmental burden than iron hydroxide coating.

Exploring the influence of gypsum coating on polyethersulfone membrane for ammonia removal in aquaculture water treatment

Preparation and Performance of Quaternary Ammonium Salt-Containing Methacrylate Copolymer-Based Ultrafiltration Membranes

Ammonia removal by adsorptive clinoptilolite ceramic membrane: Effect of dosage, isothermal behavior and regeneration process

Extraction of Hydroxyapatite from Fish Scales and Its Integration with Rice Husk for Ammonia Removal in Aquaculture Wastewater

Preparation and characterization of polysulfone/zeolite mixed matrix membranes for removal of low-concentration ammonia from aquaculture wastewater

Ammonium ultra-selective membranes for wastewater treatment and nutrient enrichment: Interplay of surface charge and hydrophilicity on fouling propensity and ammonium rejection

Enhanced and Efficient Removal of Heavy Metals by Amino-Decorated Membranes in Coordination with Multi-Function

Performance of thin film composite membranes for ammonium removal and reuse of ammonium-enriched solution for plant growth

Ammonium enrichment and recovery from synthetic and real industrial wastewater by amine-modified thin film composite forward osmosis membranes

Simultaneous Removal of Toxic Ammonia (NH3/NH4 +) from Aqueous Solutions Using New Geomaterial Adsorbent: Application to Aquaculture Effluents

Novel ceramic hollow fibre membranes contactor derived from kaolin and zirconia for ammonia removal and recovery from synthetic ammonia

Exploitation of Amine Groups Cooped up in Polyamide Nanofiltration Membranes to Achieve High Rejection of Micropollutants and High Permeance of Divalent Cations

Membrane Biofouling Control by Surface Modification of Quaternary Ammonium Compound Using Atom-Transfer Radical-Polymerization Method with Silica Nanoparticle as Interlayer

Fouling Control in Ceramic Nanofiltration Membrane: Forward Flush and Precoating Method

Presence of powdered activated carbon/zeolite layer on the performances of gravity-driven membrane (GDM) system for drinking water treatment: Ammonia removal and flux stabilization

Surface functionalization of polytetrafluoroethylene membrane by polydopamine and quaternary ammonium compound for fouling mitigation in membrane distillation of secondary effluent

Research On The Application Of Membrane Absorption For The High Concentration Ammonia Wastewater Treatment

Insights into Simultaneous Ammonia-Selective and Anti-Fouling Mechanism over Forward Osmosis Membrane for Resource Recovery from Domestic Wastewater

Treatment of highly iron-contaminated brackish groundwater by MF, UF, and NF membranes for potable water resource production: influence of operating parameters, comparative study, membrane fouling, and machine learning modeling

Preparation and performance of acrylic acid grafted PES ultrafiltration membrane via plasma surface activation

Development of an efficient, low-operating-pressure graphene oxide/polyethersulfone nanofiltration membrane for removing various water contaminants