Abstract:A combined computational/experimental study is performed to investigate hypersonic low-density internal gas flows in a convergent-divergent nozzle over a wide range of Knudsen numbers. The numerical solutions are obtained using the direct simulation Monte Carlo (DSMC) method and the experimental measurement is conducted in the hypersonic low-density wind tunnel FengDong-19 (FD-19) at China Academy of Aerospace Aerodynamics. Rarefaction effects are found to play an important role in pressure disturbance propagation, flow separation (vortex formation), mass flow rate, velocity slip, and thermally nonequilibrium effect. Pressure disturbance propagates farther upstream with increasing free-stream Knudsen number Kn∞. Although there is no flow separation near the nozzle surface for Kn∞ = 0.1, the slip velocity is such anomalously small that it cannot suppress flow separation, thus, producing one small vortex for Kn∞ = 0.2, 0.5 and 1. Due to the presence of the continuous sheet of two-order Moffatt vortices, the skin friction coefficient does not change sign (positive to negative) in the small separated region. This indicates that the incipient and small separated flows with second-order vortices may not be discerned by examining the sign of the skin friction. As Kn∞ grows to 2, this small vortex disappears. However, with further increase in Kn∞, a large vortex nearly fills the compression section of the nozzle due to the backflow effect. As Kn∞ increases from continuum to free molecular regime, the dimensionless mass flow rate mfr/mfr∞ rises first to its maximum at Kn∞ ∼ 0.2 resulting from the weaker flow blockage effect. After the maximum point, mfr/mfr∞ dwindles first because of the stronger backflow effect and rises again to its free molecular limit, obtaining its minimum (the so-called Knudsen minimum) at Kn∞ ∼ 10. DSMC results and experimental data obtained from FD-19 wind tunnel are in good agreement, achieving a mutual validation between computation and experiment. This indicates that our experiment provides valuable data that can server as “benchmark” case to support computational code evaluation and validation.

Numerical Simulation Of The Gas Dynamics Of Nitrogen Jets Exhausting Into A Rarefied Space

Modeling and numerical simulation of gas-solid jet in the transitional-rarefied regime

Numerical and Experimental Simulation of Supersonic Gas Outflow into a Low-Density Medium

Three-Dimensional Numerical Simulation of Air Exhausted from Submerged Nozzles

Numerical simulation of cavitating flow in liquid Nitrogen through a convergent nozzle

Numerical Study on Laminar Round Jet of High Density Gases Discharging into Stagnant Air.

Supersonic Gas Flow From An Annular Nozzle Into A Low-Pressure Chamber With An Axial Channel: Kinetic And Continuum Solutions

A Numerical Study of the Flow Field Driven by a Submerged, High-Speed, Gaseous Jet

STUDY ON NUMERICAL SIMULATIONS OF A PLUG NOZZLE FOR ROCKET ENGINE

Numerical study of a dense gas–solid jet flow

Numerical Analysis of Rarefied Gas Flow through a System of Short Channels

Numerical Simulation of the Micro-Jet Velocity and Cavitation-Erosion on an Axisymmetric Nozzle

A numerical model for dense particle-laden jets

Numerical Research on Nitrogen Spontaneous Condensation in Converging-Diverging Nozzle

Direct Numerical Simulation of Subsonic Round Turbulent Jet

Numerical simulation of high-speed turbulent water jets in air

Modeling of dynamics of supercritical water jet outflowing from a thin nozzle

Numerical and Experimental Investigation of Rarefied Hypersonic Flow in a Nozzle

DIRECT NUMERICAL SIMULATION OF TURBULENT PROPERTIES IN THE NEAR-FIELD REGION OF COMPRESSIBLE SPATIALLY EVOLVING AXISYMMETRIC JETS

Numerical Simulation of the Supersonic and Under-Expanded Jet Flow

A Numerical Study of Fluid Injection and Mixing under Near-Critical Conditions