Abstract:This paper firstly performed an extensive investigation of a 30.2 m basement excavation (9310 m(2) in plan) in Hangzhou soft clay. The 52 m-deep diaphragm walls and six levels of concrete struts were adopted as retaining structures to reduce the deformations caused by excavation with the bottom-up method. To comprehensively study the characteristics of this large-scale excavation, the behaviors of diaphragm walls, struts, columns, the maximum wall deflection rate, ground surface settlement and utility pipelines were focused and investigated during the whole excavation process. Based on the analyses of measured data, the following major conclusions were obtained: (i) The wall and the ground experienced a maximum displacement increment in stage 6 which was the coupled product of the "creep effect" of Hangzhou soft clay and the "depth effect" of excavation. (ii) The soil excavated in deep can produce greater stress release than the soil excavated in shallow. However, the cast of base slabs can constrain the inward wall movements and the followed horizontal ground movements successfully. (iii) Benefit from the integrity of 52-m-deep diaphragm walls and six levels of concrete struts, more-uniform movements of the column in the vertical direction were produced. (iv) The ground surface and the utility pipelines experienced more time-dependent settlement due to the much longer exposure duration time in stage 4. (v) In this project, deflections near the excavation middle were up to 3.5 times of those near corners, implying that for a large excavation not adopting the zoned excavation technique, the behaviors of corner-stiffening are significant. (vi) A general relation between the excavation area and wall deflection was also presented based on this and 16 similar cases.

Centrifuge modelling of supported excavations using an improved in-flight excavation tool

Evaluation of deformation for two-dimensional (2D) and three-dimensional (3D) braced excavation in clays with centrifuge modelling and numerical analysis

CENTRIFUGAL MODEL TESTS ON HYDRAULIC HEAVE MECHANISM OF EXCAVATION IN COHESIVE SOIL WITH CONFINED WATER

Centrifugal Model Test and Numerical Analysis of Deformation and Stability of Seawall on Soft Clay

An Efficient Method for Evaluating the Ground Surface Settlement of Hangzhou Metro Deep Basement Considering the Excavation Process

Observed Performance of a 30.2 M Deep-Large Basement Excavation in Hangzhou Soft Clay

Centrifuge Modelling of Lateral Cyclic Behaviour of a Tetrapod Piled Jacket in Soft Clay

Characteristics of Excavation-Induced Deformation Associated with Different Propped Retaining Walls in Soft Soil

Model Design and Application for Excavation Face Stability in Upward Shield Tunneling

Observed Performance of a Deep Multistrutted Excavation in Hangzhou Soft Clays with High Confined Water

In-Flight Simulation of the Excavation of Foundation Pit in Centrifuge Model Tests

Design and deformation pattern simulation of deep excavation support structures

Analytical Method for the Deformation-Based Design of Retaining Walls in Asymmetric Excavation

Study Of Effect Of Supporting Parameters On Deformation Behavior Of Excavation With Composite Supporting

CENTRIFUGE MODEL TESTS ON A COHESIVE SOIL SLOPE UNDER EXCAVATION CONDITIONS

Displacement and Force Analyses of Braced Structure of Deep Excavation Considering Unsymmetrical Surcharge Effect

Centrifuge modelling of tunnelling below existing twin tunnels with different types of support

Investigation of Three-Dimensional Deformation Behavior Due to Long and Large Excavation in Soft Clays

Dynamic Deformation Control Of Retaining Structures Of A Deep Excavation

Field Performance of a Deep Multi-Strutted Excavation in Hangzhou Soft Clays

Experimental and Numerical Investigation on the Effects of Foundation Pit Excavation on Adjacent Tunnels in Soft Soil