Abstract:The foundations of power transmission towers and offshore wind turbines are prone to huge overturning moment loading from the super structure; therefore the overturning bearing capacity is crucial for the design of such foundations. To investigate the overturning bearing capacity of suction caisson foundation, four centrifuge model tests including a displacement controlled cyclic loading test, a displacement maintained loading test, a load controlled cyclic loading test and a monotonic loading test were carried out in saturated soft clay. The test results show that the instantaneous rotation center of model caisson can be simplified to be at the depth of about four fifths of the skirt length right below the lid center, when the ultimate capacity was reached. When the amplitude of the cyclic moment is smaller than three-fifths of the bearing capacity moment, the rotation of the caisson cease to accumulate, and gradually become stable. The stiffness of the soil-structure interaction significantly softened under cyclic loading, and a threshold of cyclic degradation factor t = 0.15 can be obtained from the peak stiffness curves of the caisson. The moment-rotation curve of peak value of maintaining tests is universally quite in accordance with that of monotonic loading test. The capacity of the model caisson corresponding to the moment-rotation curve of the valley values is much lower than that corresponding to the moment-rotation curve of the peak values in maintaining tests, and a 30%-40% reduction is needed when considering the maintaining overturning capacity of the caisson foundation in design.

CENTRIFUGE MODEL TESTS ON A COHESIVE SOIL SLOPE UNDER EXCAVATION CONDITIONS

Centrifuge Model Tests on Excavation-Induced Failure of Slopes

CENTRIFUGAL MODEL TESTS ON HYDRAULIC HEAVE MECHANISM OF EXCAVATION IN COHESIVE SOIL WITH CONFINED WATER

Development and Application of a Slope Excavation Device for Centrifugal Model Tests

Time Effect of Slope Deformation under Multi-Excavation Conditions

Centrifuge Model Test Study of Structuralized Cemented Slopes under Excavation Conditions

Centrifuge model test on suction caisson foundation in soft clay subjected to lateral loads

Centrifuge Modeling of Soil Slopes Overlying Bedrock under Excavation Conditions

Centrifuge Model Test on Excavation-Induced Failure of Soil Slopes Overlying Bedrock

Centrifuge modeling of failure behavior of pile-reinforced slope

Centrifuge Model Tests on Geotextile-Reinforced Slope in Situation of Excavation

Centrifuge model test on failure of soil slope under drawdown of water level

Centrifuge Modeling Of Progressive Failure Of Soil Slope

Centrifuge modeling of cohesive soil slopes reinforced by stabilizing piles

Centrifuge Modeling of the Progressive Failure of A Soil Slope under Cyclic Loading Conditions

In-Flight Simulation of the Excavation of Foundation Pit in Centrifuge Model Tests

Study Of Stress And Displacement Fields In Centrifuge Modeling Of Slope Progressive Failure

Centrifuge Modeling of the Pile Foundation Reinforcement on Slopes Subjected to Uneven Settlement

Centrifuge model tests and numerical simulation on progressive failure behavior of slope above a mine-out area

Centrifuge Modeling of Drying–Wetting Cycle Effect on Soil Slopes

Centrifuge Modeling of a Saturated Clay Ground under Cyclic Loading