Abstract:Lithium ion batteries are essential power sources for mobile electronic devices like cell phones, tablets and increasingly used in the field of electromobility and energy transition. The commonly applied liquid electrolytes in commercial cells contain a conducting salt at relatively high concentration (LiPF6, ≥1 mol/L). For analytical battery electrolyte investigations, it is necessary to protect the column and mass spectrometer from salt precipitation and clogging. Thus, dilution of the sample is necessary which results in higher limits of detection and limits of quantification. In this study, a comprehensive online sample preparation approach for reversed phase liquid chromatography with an online-solid phase extraction was developed, which allows higher injections volumes and lower dilution factors. For the method development of the online-solid phase extraction, pristine electrolytes were used with trimethyl phosphate and triethyl phosphate as model substances for organo(fluoro)phosphates with weak and strong retention on the extraction column. Organo(fluoro)phosphates are potential hazardous decomposition products, due to their structural similarity to chemical warfare agents like sarin, and therefore their quantification is beneficial for toxicological assessment. The optimization of chromatographic parameters was performed using electrochemically aged electrolytes. For substance independent quantification with a plasma-based technique, an isocratic separation method was implemented. Using optimized conditions, LiPF6 could be removed quantitatively and the injection volume was increased up to a factor of 50, while the dilution factor could be decreased up to a factor of ten. Eleven different organo(fluoro)phosphates with an overall concentration of 133 mg/kg were found. Therefore, limit of detection and limit of quantification were improved significantly (LOQ: ≤100 µg kg-1 phosphorus content, LOD: ≤35 µg kg-1 phosphorus content). In summary, a fast online sample preparation for liquid chromatographic investigations of lithium ion battery electrolytes was implemented, validated on electrochemically aged lithium ion battery electrolyte.

Ion chromatographic quantification of nine cationic components in pre-blast and post-blast residues of pyrotechnic samples

Rapid Analysis of Pharmaceutical and Personal Care Products by Soft Microwave-Based Plasma Ionization-Linear Ion Trap Mass Spectrometer (SMPI-LTQ) in Natural Water.

Quantitative Detection of Hexamethylene Triperoxide Diamine in Complex Matrix by Dopant-assisted Photoionization Ion Mobility Spectrometry

[Determination of inorganic ions in explosive residues by capillary zone electrophoresis].

Application of LC-QTOF/MS for the validation and determination of organic explosive residues on Ionscan® swabs

Simultaneous Determination of Inorganic Anions and Cations in Explosive Residues by Ion Chromatography.

A fast method for monitoring of organic explosives in soil: a gas temperature gradient approach in LC–APCI/MS/MS

Simultaneous Determination of Organic and Cationic Species in Explosives Residues with Column-Switching Liquid Chromatography-Ion Chromatography System

EDTA‐Assisted MPT‐MS for Trace Analysis of Heavy Metals in Fireworks

Detection Of Explosives And Related Compounds By Low-Temperature Plasma Ambient Ionization Mass Spectrometry

Micellar electrokinetic chromatography of organic and peroxide-based explosives

Detection of Trace Explosives Using a Novel Sample Introduction and Ionization Method

Dual Ambient Sampling Hollow Cathode Discharge Ionization-Mass Spectrometry System: An Approach for Detecting Explosives and Drugs of Abuse at Trace to Ultratrace Levels

Online sample pretreatment for analysis of decomposition products in lithium ion battery by liquid chromatography hyphenated with ion trap-time of flight-mass spectrometry or inductively coupled plasma-sector field-mass spectrometry

Direct Detection of Explosives on Solid Surfaces by Mass Spectrometry with an Ambient Ion Source Based on Dielectric Barrier Discharge

Study of consumer fireworks post-blast residues by ATR-FTIR

Confirmation of Solid Phase Extracted Post‐Blast Explosives Residues Analyzed Using Pulsed Split Injection GC/MS

Rapid Quantification of Ammonium Nitrate and Urea Nitrate Using Liquid Chromatography-High-Resolution Orbitrap Mass Spectrometry

Detection of nitroaromatic and cyclic nitramine compounds by cyclodextrin assisted capillary electrophoresis quadrupole ion trap mass spectrometry

Fast sample preparation for organo(fluoro)phosphate quantification approaches in lithium ion battery electrolytes by means of gas chromatographic techniques

Trace detection of styphnate from pre- and post-blast samples by hydrophilic interaction chromatography with tandem mass spectrometry