Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Joining thin-walled structures without protuberance by two-strokes flattening clinching process

Research on the material flow and joining performance of two-strokes flattening clinched joint

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Strengthening of Composite T-joints Using Ø 0.11 Mm Z-pins Via an Ultrasound-Guided Insertion Process

Recent development of improved clinching process

Effects of sheet thickness and material on the mechanical properties of flat clinched joint

Effect of blank holder force on joining quality of the flat clinch-rivet process

A Comparative Study of Local Heat Treatment for Enhancing Overall Mechanical Properties of Clinched Joints

Experimental investigation of the novel dieless clinching process free of blank holder

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Investigation of the flat-clinching process for joining three-layer sheets on thin-walled structures

Influence of sheet thickness on mechanical behaviors of the clinched joints produced by single-point butt clinching process

Steel‐aluminum clinched joints mechanical properties and strength prediction under different geometric parameters

Center-Punching Mechanical Clinching Process for Aluminum Alloy and Ultra-High-Strength Steel Sheets

Research on a single-point butt clinching process with various forming forces

Investigation of the clinching process with rectangle punch

Study on In-Plane Behavior of Thin-walled Concrete-filled Steel Tubular Gusset Plate T-joints

Performance enhancement of clinched joints with ultrasonic welding for similar and dissimilar sheet metals

Finite element methods used in clinching process

Experimental Study on Tensile Fracture Mechanism of Butt Joints in Multi-Celled CFST Walls

Mechanical Clinching Process with Preforming of Lower Sheet for Joining Aluminium and Ultra-High Strength Steel Sheets