Abstract:Traditional machine learning methods assume that training and testing data must be from the same machine running condition (MRC) and drawn from the same distribution. However, in several real-time industrial applications, this assumption does not hold. The traditional methods work satisfactorily in steady-state conditions but fail in time-varying conditions. In order to utilize time-varying data in variable MRCs, this article proposes a novel low-level knowledge transfer framework using a deep neural network (DNN) model for condition monitoring of machines in variable running conditions. The low-level features have been extracted in time, frequency, and time–frequency domains. These features are extracted from the source data to train the DNN. The trained DNN-based parameters are then transferred to another DNN, which is modified according to the low-level features extracted from the target data. The proposed approach is validated through three case studies on: 1) the air compressor acoustic data set; 2) the Case Western Reserve University bearing data set; and 3) the intelligent maintenance system bearing data set. The prediction accuracy obtained for the above case studies is as high as 100%, 93.07%, and 100%, respectively, with fivefold cross-validation. These real-time results show considerable improvement in the prediction performance using the proposed approach. Note to Practitioners—Condition-based monitoring schemes are widely applicable to rotating machines in various industries since they operate in tough working situations, and consequently, unpredicted failures occur. These unpredicted failures may cause perilous accidents in the industries. CBM systems prevent such failures, which results in the reduction of equipment damage and, hence, increases machinery lifetime. Modern industries are so complex and generating huge -ata, and these data can be collected using sensors, but placing a large number of sensors is difficult and expensive for different but similar kinds of faults in industries. This also increases the cost due to additional sensors and circuits. In this article, the authors have proposed a novel low-level knowledge transfer framework using the deep neural network (DNN)-based method for condition monitoring of machines in variable running conditions. Low-level features have been extracted to reduce the computations of DNN drastically with improved performance. This article also considered additional faults in the target domain, which is more practical in real-time applications. The proposed scheme has been validated with three case studies on acoustic and vibration signatures.

Recurrent Neural Network Based Modelling of Industrial Grinding Time Series Data

Recurrent Neural Networks for Recursive Identification of Nonlinear Dynamic Process

Neural Network Based Nonlinear Autoregressive Models for CNC Machine Process

Multi-grain Cascade Recurrent Neural Network for Nonlinear Time-varying Process Soft Sensor Modeling

Graph Neural Networks for Leveraging Industrial Equipment Structure: An application to Remaining Useful Life Estimation

Recurrent neural networks with long term temporal dependencies in machine tool wear diagnosis and prognosis

Identification and Expert Approach to Controlling the Cement Grinding Process Using Artificial Neural Networks and Other Non-Linear Models

Neural Network Based Modelling and GRA Coupled PCA Optimization of Hole Sinking Electro Discharge Micromachining

Multivariate Deep Reconstruction Neural Network for Multi-step-ahead Prediction of Industrial Process Quality Variables

An efficient neural-network model for real-time fault detection in industrial machine

Identification of Non-Stationary Objects Based on Training a Neural Network and Tuning the Parameters of a Generalized Model

Development of input variable selection and structural optimization algorithm for recurrent neural network

Multi-Objective Optimization of the Process Parameters of a Grinding Robot Using LSTM-MLP-NSGAII

Parameter Identification of Cutting Forces in Crankshaft Grinding Using Artificial Neural Networks

Evaluation of neural network models and quality forecasting based on process time‐series data

Automatic Structure and Parameter Training Methods for Modeling of Mechanical System by Recurrent Neural Networks

First Steps through Intelligent Grinding Using Machine Learning via Integrated Acoustic Emission Sensors

Multi-scale time series analysis using TT-ConvLSTM technique for bearing remaining useful life prediction

Condition-Based Monitoring in Variable Machine Running Conditions Using Low-Level Knowledge Transfer With DNN

Automated contour mill-tool grinding path generation via deep learning

Application of recurrent neural network to mechanical fault diagnosis: a review