Abstract:Due to the strong biological penetration, large stoke shift, good photostability and biocompatibility, up-conversion nanoparticles (UCNPs) were widely used in biomedical analysis. In this study, OA-UCNPs, which are UCNPs with oleic acid (OA) as ligand, were modified by polyacrylic acid (PAA)in order to prepare hydrophilic nanoparticles PAA-UCNPs, and then aptamers (Apt) were covalently coupled to the surface of PAA-UCNPs by amidation reaction to obtain Apt-UCNPs. A method for specific detection of sulfadimethoxine (SDM)was constructed by using Apt-UCNPs as energy donors and black hole quencher (BHQ1) as an energy acceptor fluorescence resonance energy transfer. The structure and performance of UCNPs, PAA and PAA-UCNPs were characterized by infrared spectroscopy (FTIR) and scanning electron microscope (SEM). The results of FTIRshowed that compared with UCNPs, PAA-UCNPs appeared at a new peak at 1 722 cm which was attributed to the -C=O stretching vibration peak of PAA, and the wide band around 3 400 cm(-1) attributed to the O-H stretching vibration of PAA; the results of the SEM test indicated that the size of UCNPs and PAA-UCNPs was 31 and 49 nm, respectively. It may be because the molecular volume of long-chain PAA is larger than that of oleic acid, so coating on the surface of UCNPs will increase its size, and the above results indicated PAA may have had been modified to the surface of UCNPs. The structure and properties of Apt-UCNPs, Apt and PAA-UCNPs, were characterized by ultraviolet-visible spectroscopy. It was found that compared with PAA-UCNPs, Apt-UCNPs had a more obvious Apt characteristic absorption peak at 260 nm, which showed that the aptamer could have been modified to the surface of UCNPs. In addition, the mechanism of using Apt-UCNPs to detect SDM was also discussed. The results showed that the emission peak of Apt-UCNPs at 540 nm overlapped with the absorption peak of BHQ1, which indicated that the energy on Apt-UCNPs can be transferred to BHQ1 through the fluorescence resonance energy transfer effect so that the fluorescence of Apt-UCNPs could be quenched. The concentration of BHQ1 in the detection system was optimized and the results showed that when the concentration of BHQ1 was 15 mu mol.L-1, the fluorescence quenching efficiency was as high as 55%. Under the best experimental conditions, there was a good linear relationship between the relative fluorescence intensity and the SDM concentration (150 similar to 1 000 ng.mL(-1)). The analogues of SDM (sulfapyridine and sulfacetamide) were selected as control experiments. It was found that although the concentration of sulfapyridine and sulfacetamide reached 500 ng.mL(-1), the fluorescence intensity recovery in the system was less, which indicated that the detection method could specifically recognize SDM.

Amplified photocurrent signal for fabricating photoelectrochemical sulfadimethoxine aptasensor based on carbon nitride photosensitization with visible/near-infrared light responsive zinc phthalocyanine

Photoelectrochemical Aptasensor for Sulfadimethoxine Using G-C 3 N 4 Quantum Dots Modified with Reduced Graphene Oxide

Graphene-doped Bi2S3 Nanorods As Visible-Light Photoelectrochemical Aptasensing Platform for Sulfadimethoxine Detection.

Photoelectrochemical aptasensor for sulfadimethoxine using g-C3N4 quantum dots modified with reduced graphene oxide

A colorimetric aptasensor for sulfadimethoxine detection based on peroxidase-like activity of graphene/nickel@palladium hybrids

New two-dimensional nanocomposites combined with target-induced strategy in an electrochemical aptasensor for sensitive determination of sulfadimethoxine

A Novel and Sensitive Electrochemical Aptasensor for Sulfadimethoxine Detection Based on the Triple Helix/exonuclease I-assisted Double-Amplification Strategy.

Voltammetric aptasensor for sulfadimethoxine using a nanohybrid composed of multifunctional fullerene, reduced graphene oxide and Pt@Au nanoparticles, and based on direct electron transfer to the active site of glucose oxidase

An Electrochemical Aptamer Sensor for Rapid Quantification Sulfadoxine Based on Synergistic Signal Amplification of Indole and MWCNTs and Its Electrooxidation Mechanism

Study on Specific Detection of Sulfadimethoxine Based on Aptamer-Modified Up-Conversion Fluorescent Nanomaterial

An Aptamer-Based Colorimetric/sers Dual-Mode Sensing Strategy for the Detection of Sulfadimethoxine Residues in Animal-Derived Foods.

A practical aptaprobe for sulfadimethoxine residue detection in water and fish based on the fluorescence quenching of CdTe QDs by poly(diallyldimethylammonium chloride)

Ultrasensitive photoelectrochemical aptasensor for carbendazim detection based on in-situ constructing Schottky junction via photoreducing Pd nanoparticles onto CdS microsphere

Bimetallic PtNi nanozyme-driven dual-amplified photoelectrochemical aptasensor for ultrasensitive detection of sulfamethazine based on Z-scheme heterostructured Co9S8@In-CdS nanotubes

A novel "on-off-on" electrochemiluminescence aptasensor based on resonance energy transfer as signal amplification strategy for ultrasensitive detection of sulfadiazine in different samples

A dichromatic label-free aptasensor for sulfadimethoxine detection in fish and water based on AuNPs color and fluorescent dyeing of double-stranded DNA with SYBR Green I

A Novel Colorimetric and Fluorescent Dual-Mode 3D Paper-Based Microfluidic Aptasensor for the Point-of-care Detection of Sulfadimethoxine

Label-Free Fluorescence-Based Aptasensor for the Detection of Sulfadimethoxine in Water and Fish

Enhanced photoelectric conversion efficiency: A novel h-BN based self-powered photoelectrochemical aptasensor for ultrasensitive detection of diazinon

Locking-DNA Network Regulated CRISPR-Cas12a Fluorescent Aptasensor Based on Hollow Flower-Like Magnetic MoS2 Microspheres for Sensitive Detection of Sulfadimethoxine

A Sensitive and Label-Free Photoelectrochemical Aptasensor Using Co-Doped Zno Diluted Magnetic Semiconductor Nanoparticles