Abstract:The extensive existence of microplastics in the environment has potential exposure risks. So it is very necessary to develop a reliable and accurate monitoring method. This paper has studied two quantitative methods of microplastics based on Raman spectroscopy. The first is the quantitative analysis of the mass concentration of microplastics in suspension. Raman spectroscopy was used to measure the characteristic peak intensity of microplastic suspension calibrated by silica, and the relationship between the characteristic peak intensity, and the concentration of microplastics was studied. The results showed a good correlation between the concentration of microplastics and the characteristic peak intensity (R-2 = 0. 96), but this method needed stirring and ultrasonic oscillation to prepare the suspension in advance. Before the measurement, the characteristic peak intensity of microplastic suspension should be calibrated by silica. Moreover, the result was not good when the concentration was high. All these problems reduced the practicability of this method. The second is quantitative analysis of microplastics' quality on the filter membrane's surface. The aerosol generator generates microplastic aerosol samples, which were collected on the surface of the filter membrane. Raman mapping mode was used to measure the characteristic peaks of microplastic samples on the filter to determine the existence of microplastics to determine the correlation between peak recognition frequency and the mass of microplastic on filter. The results showed a good correlation between peak recognition frequency and the mass of microplastic measured by this method ( R-2 = O. 95). However, the traditional sampling method made microplastic samples unevenly distributed in a large area and made a small proportion of the measurement area. All these problems led to a large relative measurement error (2%0 similar to 6%). In this study, aerosol micro-concentration technology was used to sample under the condition of keeping the surface deposition density of samples unchanged to reduce the deposition area of samples, reduce the collection amount of microplastic samples and increase the proportion of measurement area. The results showed that the correlation between peak recognition frequency and mass of microplastic could be effectively improved by aerosol micro-concentration technology (R-2=0. 97), and the relative measurement error could be reduced to 2%similar to 4%. This method does not need complex operations such as preparation and calibration of the microplastic suspension, and it can directly collect microplastics in the air on the filter for quantitative analysis of microplastic quality, reducing the time required for measurement. This method is expected to be applied in the real-time measurement of microplastics in the environment.

A novel thermoanalytical method for quantifying microplastics in marine sediments

A Novel Method Enabling the Accurate Quantification of Microplastics in the Water Column of Deep Ocean.

A Novel Heating-Assisted Density Separation Method for Extracting Microplastics from Sediments.

Multidecadal records of microplastic accumulation in the coastal sediments of the East China Sea

Application of Confocal Laser Raman Spectroscopy on Marine Sediment Microplastics

Novel Efficient Method to Continuously Collect Microplastics from Seawater via a Two-Phase System

Challenge for the Detection of Microplastics in the Environment

Separation and identification of microplastics in marine organisms by TGA-FTIR-GC/MS: A case study of mussels from coastal China

A new method for analyzing microplastic particle size distribution in marine environmental samples

Marine micro(nano)plastics determination and its environmental toxicity evaluation

An approach for extraction, characterization and quantitation of microplastic in natural marine snow using Raman microscopy

An Optimized Density-Based Approach for Extracting Microplastics from Soil and Sediment Samples.

Overview of analytical methods for the determination of microplastics: Current status and trends

Identification and Quantification of Microplastics in Aquaculture Environment

A modified methodology for extraction and quantification of microplastics in soil

A review of microplastics in sediments: Spatial and temporal occurrences, biological effects, and analytic methods

Quantitative Analysis of Microplastics Based on Micro-Raman Spectroscopy

Methods Matter: Methods for Sampling Microplastic and Other Anthropogenic Particles and Their Implications for Monitoring and Ecological Risk Assessment

Analysis of Environmental Nanoplastics: Progress and Challenges

The Development and Application of Advanced Analytical Methods in Microplastics Contamination Detection: A Critical Review.

An Optimized Procedure for Extraction and Identification of Microplastics in Marine Sediment.