Abstract:In recent years, non-aqueous absorbents have attracted increasing attention due to their ability of significantly reducing sensible and latent heats in regeneration processes compared to conventional organic amine aqueous solution. But high viscosity of non-aqueous absorbents after CO2 absorption saturation became an obstacle to their industrial application. Here, a novel low-viscosity diamine non-aqueous absorbent for high-efficiency CO2 capture was proposed, in which N-methyldiethanolamine (MDEA) with steric hindrance effect was introduced as a regulator and dimethyl sulfoxide (DMSO) as a cosolvent. The effects of MDEA on CO2 capture performance of various non-aqueous absorbents and its regulation mechanism on CO2 absorbent viscosity were investigated systematically. Experimental results showed that when 25 wt% 2-(2-aminoethylamino)ethanol (AEEA) was screened as main CO2 absorption component, AEEA/MDEA/DMSO non-aqueous absorbent exhibited a high CO2 absorption capacity of 2.55 mol/kg and a fast CO2 absorption rate. Based on further mass fraction optimisation, it was found that the lowest viscosity of non-aqueous absorbents after CO2 absorption was 13.12 mPa s and the highest CO2 regeneration reached 93.5 % with AEEA and MDEA were 17.5 wt% and 12.5 wt%, respectively. 13C NMR tests showed that two characteristic peaks of carboxylated carbon appeared in CO2 products, which indicated that both amino groups on AEEA molecule were involved in CO2 absorption reaction. DFT calculations indicated that hydrogen bonding strength between MDEA and CO2 products was relatively lower than that of AEEA and CO2 products, which favored reducing absorbent saturation viscosity significantly. Thermodynamic analysis revealed that total regeneration energy consumption for 17.5 wt% AEEA/12.5 wt% MDEA/70 wt% DMSO non-aqueous absorbent was 1.72 GJ/t CO2, which was 53 % lower than that of MEA aqueous solution.

Amino acids to reduce the escape of organic amines in the CO 2 capture process

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Hybrid Behaviors of CO2 Absorption into Blended DEEA‐based Solution for the Improvement of Capture Performance

Target-specific Modification of Diethylenetriamine with Hydroxyalkyls: Efficient Absorbents for CO2 Capture

Evaluation on water balance and amine emission in CO2 capture

Enhancing CO2 capture of an aminoethylethanolamine-based non-aqueous absorbent by using tertiary amine as a proton-transfer mediator: From performance to mechanism

Target-specific modification of diethylenetriamine with hydroxyalkyls: Efficient absorbents for CO 2 capture

Research of Novel Polyamine-Based Biphasic Absorbents for CO2 Capture Using Alkanolamine to Regulate the Viscosity and Mechanism Analysis

Research of novel polyamine-based biphasic absorbents for CO 2 capture using alkanolamine to regulate the viscosity and mechanism analysis

Volatility of 2-(diethylamino)-ethanol and 2-((2-aminoethyl) amino) ethanol, a biphasic solvent for CO2 capture

Design and performance evaluation of low-volatility and low-viscosity absorbents for CO2 capture

Research Progress on Amine Absorbent for CO2 Capture from Flue Gas

[CO2 absorption and regeneration performance of a natural amino acid and its potassium salt]

Reducing aerosol and ammonia emission in post-combustion CO 2 capture: Additives as key solutions

Investigation on CO2 Capture Performance of Low-Viscosity Diamine Non-Aqueous Absorbents with N-methyldiethanolamine Regulation

A Novel Diamine Non-Aqueous Absorbent Based on N-methyl diethanolamine Regulation for Energy-efficient CO2 Capture

Intensification of Amino Acid Ionic Liquids with Different Additives for CO2 Capture

Novel Amino Acid Ionic Liquids As Messenger of Multi-Tertiary-amines Solutions for Highly Efficient Capture of CO2

Study on performance of alkanolamines as absorbents for CO2 capture

Novel Amino-Functionalized Ionic Liquid/Organic Solvent with Low Viscosity for CO2 Capture