Effect of Fe3+ concentration and pH on arsenic removal, migration and speciation transformation in lab-scale wet flue gas desulfurization system

Kaihua Zhang,Chuanfeng Wang,Peng Wang,Kai Zhang
DOI: https://doi.org/10.1016/j.fuel.2021.120633
IF: 7.4
2021-07-01
Fuel
Abstract:<p>Wet flue gas desulfurization (WFGD) system of coal-fired power station can synergistically remove arsenic from flue gas. However, the detailed mechanism of arsenic removal by desulfurization slurry and its further migration and transformation from gas to desulfurization products still remains unclear. In this study, two important factors, the Fe<sup>3+</sup> concentration and the pH value, were investigated for their effects on arsenic removal, redistribution and transformation in a lab-scale reactor. The results show low Fe<sup>3+</sup> concentration (≤1 mg L<sup>-1</sup>) in slurry may lead to the decrease of particle size and the increase of Zeta potential of gypsum particles, thus promoting arsenic removal from flue gas, while more Fe<sup>3+</sup> (10–500 mg L<sup>-1</sup>) could reduce its removal due to the increase of mass transfer resistance. Arsenic removal efficiency decreases with pH value rising. The slurry with Fe<sup>3+</sup> is easier to remove As(III) from flue gas than As(V) due to the strong polarity of AsCl<sub>3</sub>(g). Either increasing Fe<sup>3+</sup> concentration (pH = 5.5) or rising pH value (Fe<sup>3+</sup> concentration = 50 mg L<sup>-1</sup>) can promote arsenic migration from desulfurization wastewater into gypsum. At any pH value, Fe-gypsum has a stronger ability to adsorb As(V) than As(III). Acid leaching model test indicates the arsenate incorporated into gypsum lattice can reach 12% without Fe<sup>3+</sup>, but the presence of Fe<sup>3+</sup> hinders the arsenate doped into gypsum crystal, which is less than 1%. This raises the potential environmental risk of further utilization of gypsum due to the unstable arsenic speciation. The main arsenates substituting SO<sub>4</sub><sup>2-</sup> doped into gypsum lattice are HAsO<sub>4</sub><sup>2-</sup> and AsO<sub>4</sub><sup>3-</sup>.</p>
energy & fuels,engineering, chemical
What problem does this paper attempt to address?