Abstract:A novel coaxial mixer was proposed, which had an outer wall-scraping frame and a combined inner impeller consisting of a four-pitched-blade turbine paddle (PBT-4) and a Rushton turbine paddle (RT-6). Its heat transfer performance in Newtonian fluid under different operating modes (single rotation of inner impeller, corotation and counter-rotation) was experimentally investigated in a stainless steel agitated vessel with semicircle spiral jacket and ellipsoidal head by measuring the average heat transfer coefficient of the inner wall. Meanwhile, the wall temperature, the heat flow rate and the local heat transfer coefficient in the coaxial agitated vessel were determined with the help of numerical simulation. The results show that the heat transfer coefficient near the inner wall surface of the agitated vessel will increase with the increasing speed of the inner or outer impeller whether under single-shaft agitation or under coaxial agitation mode, whereas the effect of speed of the inner impeller on heat transfer is more obvious and efficient. Under the same conditions, the heat transfer of coaxial agitation is more efficient than that of single-shaft agitation, especially the local heat transfer coefficient on the upper and lower part of the agitated vessel, which is increased greatly. In addition, the local heat transfer coefficient varies with the axial position of the agitated vessel, and the heat transfer coefficient in zones between the upper and lower impeller is relatively high. The effect of the corotation mode and counter-rotation mode on heat transfer is of little difference, but the corotation mode is recommended owing to its advantage of low power consumption and good mixing performance.

Estimation of mean shear rate in a vessel of a planetary centrifugal mixer based on the heat balance equation

Numerical Investigation on Hydrodynamics and Heat Transfer of Highly Viscous Fluid in Sulzer Mixer Reactor

Numerical Simulation of Hydrodynamics and Mixing Characteristics of High-Viscosity Non-Newtonian Fluid in Twin-Shaft Kneaders

Micro-Mixing Enhancement in a Taylor-Couette Reactor Using the Inner Rotors with Various Surface Configurations

Numerical and experimental study of homogenization mechanism of high shear rotor‐stator mixer

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer

Experimental Research on the Power Consumption of a Coaxial Mixer in a Fluid with High Viscosity

Research on Heat Transfer Performance of Coaxial Mixer with Inner Combined Impeller

Power Consumption and Flow Field Characteristics of a Coaxial Mixer with a Double Inner Impeller

Experimental and Numerical Study on Flow Resistance and Bubble Transport in a Helical Static Mixer

Numerical Simulation of Rotor-stator Mixer with Viscous Fluids

Numerical Analysis of Viscous Polymer Resin Mixing Processes in High-Speed Blade-Free Planetary Blender Using Smoothed Particle Hydrodynamics

Numerical Simulation of Power Consumption and Mixing Characteristic in Stirred Vessel with Novel Coaxial Mixer

Precessing cylinder as high-shear-rate mixer: Application to emulsification

Numerical Study on Particle Mixing in a Double-Screw Conical Mixer

Direct Numerical Simulation Of Turbulent Heat Transfer In An Axially Rotating Pipe Flow - Reynolds Shear Stress And Scalar Flux Budgets

Experimental Study on Gas–liquid Dispersion and Mass Transfer in Shear-Thinning System with Coaxial Mixer

Influence of Fluid Viscosity on Vortex Cavitation at a Suction Pipe Inlet

Numerical Investigation and Estimating Correlation of Micromixing Performance of Coaxial Mixers

A numerical study on the mixing time prediction of miscible liquids with high viscosity ratios in turbulently stirred vessels

Experimental study on gas-liquid flow regimes of coaxial mixers equipped with a Rushton/pitched blade turbine and anchor