Abstract:Simulation and theoretical investigation of a novel FRP rope. The study proposed using twisted rope made of flexible fiber‐reinforced polymers (FRPs) instead of wire and synthetic ropes in high load‐bearing and corrosive environments. Finite element model verification and parameter analysis were conducted for the rope, along with deriving theoretical equations for its tensile properties. Increasing the lay length improved model accuracy, with a maximum bearing capacity within a 10% margin of error compared to experimental results. The model length had minimal impact on calculation results, while changes in radial mesh size (0.13 and 0.2 mm) and friction coefficient (0–0.2) greatly affected maximum contact stress. The tensile strength and elastic modulus of the strand remained almost constant (approximately 1142 MPa and 44 GPa) when the friction coefficient was altered. Increasing lay length (6D–20D) enhanced the tensile properties of the strand, whereas tendon diameter (1–3 mm) had negligible impact. Arranging inner and outer strands with the same lay length was better for circular ropes than those with the same lay angle. Inverse lay direction reduced rope torque and increased strand contact stress. Rectangular ropes had higher strength and modulus conversion efficiency, with lower contact stress compared to circular ones. The accuracy of rope equations improved with longer lay lengths, and adding a correction factor for lay length can modify the equation. Highlights A flexible FRP rope with high strength and twisted form was proposed. The effect of construction factors on the tensile behaviors of ropes was clarified. Equations for calculating the tensile properties of ropes were derived.

Experimental Characterization of Stiffness of a Polyester Mooring Rope for a CFPSO

Study on the Calculation Method for the Dynamic Behavior of Polyester Rope

A New Fully-Detailed Finite Element Model of Spiral Strand Wire Ropes for Fatigue Life Estimate of a Mooring Line

Numerical simulation of nonlinearity and viscoelasticity of synthetic fibre rope for taut moorings in deep water

Experimental Evaluation of Dimension-Stable Synthetic Fibre Rope under Investigation of Spooling Test on the Multilayer Winch Drum

Robust Contact and Friction Model for the Fatigue Estimate of a Wire Rope in the Mooring Line of a Floating Offshore Wind Turbine

A novel fiber‐reinforced polymer rope: Simulation and theoretical investigation

Load Assessment Method for Multi-Layer Oceanographic Winch with Synthetic Fibre Ropes Based on Non-Rotation Symmetric Cylindrical Model

Experimental Investigation on Responses Characteristics of a Mooring Line with Imposed Top-End Motions

Experimental investigation of spooling test on the multilayer oceanographic winch with high-performance synthetic fibre rope

Experimental study on cyclic-bend-over-sheave (CBOS) characteristics of an HMPE fibre rope under dynamic loading

Experimental measurement for dynamic tension fatigue characteristics of HMPE fibre ropes

Floating Wind Turbine Model Test to Verify a moordyn Modification for Nonlinear Elastic Materials

Lateral static stiffness of offshore monopile socketed in soft rock

A novel fiber-reinforced polymer rope: Concept design and experimental evaluation

Numerical simulation with hyperelastic constitutive model for high-performance multifilaments used in offshore mooring ropes

Experimental-based statistical models for the tensile characterization of synthetic fiber ropes: a machine learning approach

Cyclic testing of continuously wetted synthetic fiber ropes

Numerical study of rope materials of the mooring system for gravity cages

Time-varying dynamic performance of a floating platform-mooring system based on the mechanical experimental data derivation method for corroded wire ropes

Effects of Damaged Fiber Ropes on the Performance of a Hybrid Taut-Wire Mooring System