Abstract:In the emerging market of electric vehicles (EVs), the development of batteries with higher energy density and improved cycle-life is essential. 1 Silicon-based anodes can significantly improve the energy density due to the huge specific capacity of ~3600 mAh/g Si , (corresponding to the Li 15 Si 4 phase 2 ) which is roughly ten times larger compared to conventional graphite electrodes (372 mAh/g C 3 ). However, the alloying of silicon with lithium is accompanied by large structural changes, resulting in a volume increase by 310% upon full lithiation. 2 This causes fast degradation of the capacity due to particle cracking, loss of electric and ionic conductivity, increasing electrode polarization and continuous electrolyte consumption. 4-6 In this work we will investigate the consumption of the electrolyte additive fluoroethylene carbonate (FEC) which is known to significantly improve the lifetime of Li-ion batteries with silicon anodes. 7 Fig. 1 shows the cycling stability and coulombic efficiency of Si/C composites (40% wt nano-Si, 40% wt VGCF fibers, and 20% wt LiPAA binder; 1.2 mg Si /cm 2 ) cycled in coin cells with metallic lithium counter electrodes and LP57 electrolyte containing various amounts of FEC. A striking feature is a rapid capacity drop which is delayed to higher and higher cycle numbers as more FEC is added to the electrolyte. By the use of 19 F-NMR spectroscopy we demonstrate that the rapid capacity drop is due to the total consumptions of FEC. Its depletion causes a significant increase of the cell polarization, leading to the rapid capacity drop. We show with On-line Electrochemical Mass Spectrometry (OEMS) that the presence of FEC in the electrolyte prohibits the reduction of other electrolyte components almost entirely. Consequently, the cumulative irreversible capacity until the rapid capacity drop correlates linearly with the specific amount of FEC (in units of μmol FEC /mg electrode ) in the cell. The lifetime of silicon anodes is therefore determined by the specific amount of FEC rather than by the FEC concentration. By correlating the cumulative irreversible capacity and the specific amount of FEC in the cell, we present an easy tool to predict how much cumulative irreversible capacity can be tolerated until all FEC will be consumed in either half-cells or full-cells. We further demonstrate that four electrons are consumed for the reduction of one FEC molecule and that one carbon dioxide molecule is released for every FEC molecule that is reduced. Using all information from this study and combining it with previous reports in the literature, a new reductive decomposition mechanism for FEC is proposed yielding CO 2 , LiF, Li 2 O, Li 2 CO 3 , H 2 and a partially cross-linked polymer. Fig. 1. (a) Coulombic efficiency and (b) specific lithiation capacity vs. cycle number of Si-Li coin cells with 75 μL LP57 electrolyte containing different amounts of FEC. The first three cycles are conducted at C/10 followed by cycling at C/3. The theoretical capacity is 1440 mAh/g electrode and the specific amount of FEC (in μmol FEC /mg electrode ) is specified in the figure. References: McDowell, M. T.; Lee, S. W.; Nix, W. D.; Cui, Y., Adv. Mater. (Weinheim, Ger.) , 25 , 4966 (2013). Obrovac, M. N.; Christensen, L., E lectrochem. Solid-State Lett. , 7 , A93 (2004). Kasavajjula, U.; Wang, C.; Appleby, A. J., J. Power Sources , 163 , 1003 (2007). Fuchsbichler, B.; Stangl, C.; Kren, H.; Uhlig, F.; Koller S.;, J. Power Sources , 196 , 2889 (2011). Christensen, J.; Newman, J., J. Electrochem. Soc. , 151 , A1977 (2004). Christensen, J.; Newman, J., J. Electrochem. Soc. , 152 , A818 (2005). Etacheri, V.; Haik, O.; Goffer, Y.; Roberts, G. A.; Stefan, I. C.; Fasching, R.; Aurbach, D., Langmuir , 28 , 965 (2012). Acknowledgements: BMW is gratefully acknowledged for financial support. The authors kindly thank Uta Schwenke and Morten Wetjen from our group for helpful advices and great contributions to this work. Figure 1

Unraveling Morphology and Chemistry Dynamics in Fluoroethylene Carbonate Generated Silicon Anode Solid Electrolyte Interphase Across Delithiated and Lithiated States: Relative Cycling Stability Enabled by an Elastomeric Polymer Matrix

Identifying the Structural Basis for the Increased Stability of the Solid Electrolyte Interphase Formed on Silicon with the Additive Fluoroethylene Carbonate

Improved Performance of the Silicon Anode for Li-Ion Batteries: Understanding the Surface Modification Mechanism of Fluoroethylene Carbonate As an Effective Electrolyte Additive

Effect Of Fluoroethylene Carbonate On Solid Electrolyte Interphase Formation Of The Sio/C Anode Observed By In Situ Atomic Force Microscopy

Identification of the Solid Electrolyte Interface on the Si/C Composite Anode with FEC as the Additive

Modeling Electrochemical Decomposition of Fluoroethylene Carbonate on Silicon Anode Surfaces in Lithium Ion Batteries

Effect of fluoroethylene carbonate as an electrolyte additive on the cycle performance of silicon-carbon composite anode in lithium-ion battery

Enhanced overall electrochemical performance of silicon/carbon anode for lithium-ion batteries using fluoroethylene carbonate as an electrolyte additive

Understanding the Roles of Electrolyte Additives on the Surface Modification Mechanism of Silicon-Based Anodes in Lithium-Ion Batteries

Tuning Reaction Kinetics of Fluorinated Molecules to Construct Robust Solid Electrolyte Interphases on SiOx Anode

Molecular-Cling-Effect of Fluoroethylene Carbonate Characterized via Ethoxy(pentafluoro)cyclotriphosphazene on SiOx/C Anode Materials - A New Perspective for Formerly Sub-Sufficient SEI Forming Additive Compounds

Engineering Solid Electrolyte Interphase Composition by Assessing Decomposition Pathways of Fluorinated Organic Solvents in Lithium Metal Batteries

Consumption of Fluoroethylene Carbonate (FEC) on Si-C Composite Electrodes for Li-Ion Batteries

In Situ Diffuse Reflectance Infrared Fourier-Transform Spectroscopy Investigation of Fluoroethylene Carbonate and Lithium Difluorophosphate Dual Additives in SEI Formation over Cu Anode

Understanding Fluoroethylene Carbonate and Vinylene Carbonate Based Electrolytes for Si Anodes in Lithium Ion Batteries with NMR Spectroscopy

Rectifying Solid Electrolyte Interphase Structure for Stable Multi-Dimensional Silicon Anodes

Solid–Electrolyte Interface Formation on Si Nanowires in Li-Ion Batteries: The Impact of Electrolyte Additives

Rational Electrolyte Design for Interfacial Chemistry Modulation to Enable Long‐Term Cycling Si Anode

SEI Formation and Interfacial Stability of a Si Electrode in a LiTDI-Salt Based Electrolyte with FEC and VC Additives for Li-Ion Batteries

Fluorinating Solid Electrolyte Interphase by Regulating Polymer–Solvent Interaction in Lithium Metal Batteries

Constructing LiF-Dominated Interphases with Polymer Interwoven Outer Layer Enables Long-Term Cycling of Si Anodes