Abstract:Energy consumption of electronic devices continues to reduce dramatically, enabling the ambient energy harvesting devices as a solution for powering the wireless sensor nodes (WSNs), micro-electromechanical systems and portable electronics. Over the years, vibration-based piezoelectric harvesting has been emerged as a potential technology to recharge/replace chemical batteries in WSNs. A conventional linear piezoelectric energy harvester (PEH) cannot meet the requirement of broadband vibration resources as it generates useful power only in a narrow bandwidth near the resonant frequency. Several techniques such as passive/active resonance tuning, array of harvester beams, nonlinear designs and multi-degree-of-freedom energy harvesters have been investigated. This paper proposes a generalized multi-mode PEH (MPEH) accompanied with analytical modeling, which generates multiple close peaks of voltage output from low amplitude broadband and low frequency ambient vibration sources. The proposed MPEH comprises of a main cantilevered beam bonded with a patch of piezoelectric layer and attached with multiple branches with tip masses at their free ends. The useful bandwidth and the number of peaks for the MPEH could be tuned conveniently by varying multiple branches and tip masses. The proposed MPEH offers high design flexibility in tuning geometric parameters for achieving target frequencies and generates high power density. The mathematical modeling of generalized MPEH under transverse harmonic base vibrations is presented and the dynamic equations of the multi-modal harvester system are obtained following the Lagrangian method. The derived distributed parametric model of MPEH is more accurate than lumped parametric models of PEHS presented in the literature. The accuracy of the proposed analytical model is validated by two examples with numerical simulation and experimental results. It is shown that the multi-mode PEH has potential to generate sufficient power output from broadband vibration sources to sustain low-power electronic devices. (C) 2019 Elsevier Ltd. All rights reserved.

Multi-piezoelectric energy harvesters array based on wind-induced vibration: Design, simulation, and experimental evaluation

VIV array for wind energy harvesting

Harnessing Multi-Stable Piezoelectric Systems for Enhanced Wind Energy Harvesting

An Innovative V-shaped Piezoelectric Energy Harvester for Wind Energy Based on the Fully Fluid-Solid-electric Coupling

Wind-Speed-Adaptive Resonant Piezoelectric Energy Harvester for Offshore Wind Energy Collection

Segmented layered bistable piezoelectric laminates for enhanced energy harvesting from wind‐induced vibration

Analytical Modeling and Validation of Multi-Mode Piezoelectric Energy Harvester

Modeling and Analysis of Upright Piezoelectric Energy Harvester under Aerodynamic Vortex-induced Vibration

Multi-branch Sandwich Piezoelectric Energy Harvester: Mathematical Modeling and Validation

Experimental Investigation of Three-Dimensional Multi-Directional Piezoelectric Wind Energy Harvester

A Novel Composite Multi-Layer Piezoelectric Energy Harvester

Multi-interference local pressure modulation for improving performance of piezoelectric wind energy harvesters

A Piezoelectric Energy Harvester for Multi-Type Environments

Design and analysis of the piezoelectric-electromagnetic energy harvester based on magnetically coupled structures

Design, fabrication and characterization of a wind-isolated galloping energy harvester via an embedded piezoelectric transducer

Research on Multi-DirectionalPiezoelectric-Electromagnetic CompositeVibration Energy Harvesters

An enhanced broadband piezoelectric energy harvester via elastic amplification structure for multidirectional vibration

A piezoelectric energy harvester using an arc-shaped piezoelectric cantilever beam array

Experimental Research on Wind-Induced Flag-Swing Piezoelectric Energy Harvesters

A Multi-Mode Broadband Vibration Energy Harvester Composed of Symmetrically Distributed U-Shaped Cantilever Beams

Design and Study of a Rotating Piezoelectric Energy Harvester with Dual Excitation Modules