Abstract:The global warming and greenhouse effect are increasingly severe. China is the world's largest CO2 emitter and is facing tremendous pressure to reduce CO2 emission. Analyses of CO2 emission sources in China show that coal-fired power plants, cement plants and steel mills make up the vast majority of CO2 emissions. Therefore, it is important to reduce CO2 emissions in the three industries. In order to reduce the capture cost we propose high salt effluent from the enterprise to absorb CO2. CO2 can be fixed in carbonates with Ca 2+ and Mg 2+ in high salt effluent. CO2 capture by high salt effluent can reach the combination of CO2 capture and storage. There are many steel industries in China. A large amount of slag waste is produced every year and heavy accumulation causes environmental pollution and waste of land resources. The slag with rich alkaline substances can be reinforce CO2 capture by high salt effluent. and carbonate product can be used as raw material for other industries. It achieve resource utilization of steel slag and the combination of CO2 capture and storage, and use waste to treat waste. On-line chromatography method is applied to determine the CO2 solubility in high salt effluent (simulated system) without and with steel slag (simulated system). It is studied on the influence of temperature and salinity on CO2 capture by high salt effluent and found the increase of temperature and salinity adverse to CO2 capture by high salt effluent. It is also studied on the influence of temperature, steel slag concentration, steel slag composition and their synergy on CO2 capture by high salt effluent with steel slag and found the decrease of temperature and the increase of slag concentration favor to CO2 capture, and CaO, MgO and their synergy all promote CO2 capture. Relative to temperature and salinity, the increasing concentration of steel slag has greatly promoted CO2 capture by high salt effluent, and CO2 solubility increases by 1115.56% per 1% increase in steel slag concentration. The thermodynamic model is built to study on CO2 capture by high salt effluent without and with steel slag and the average errors between calculation values and experimental values are less than 5% and explain the experimental results. The influence of temperature and salinity on CO2 capture are achieved by Henry’s constant and ionization constant. The increase of steel slag enhances the alkalinity of the solution and increases the concentration of H2CO3, HCO3 , CO3 2and improves the formation of carbonate, which promotes CO2 capture. CaO and MgO can promote CO2 capture because of high solubility in seawater and MgO is better than CaO in CO2 capture and Fe2O3 and Al2O3 have little effect on CO2 capture because of low solubility in high salt effluent. The kinetics of CO2 absorption in high salt effluent without and with steel slag was studied. The mass transfer coefficient decreases with decrease of pressure and pH. The increase of temperature, decrease of salinity and increase of slag concentration can increase mass transfer coefficient and promote CO2 absorption rate. In composition of steel slag, Fe2O3 can increase CO2 absorption rate. Finally, the process of CO2 capture by high salt effluent without and with steel slag were built by Aspen Plus. The effluence of temperature, pressure, liquid-gas ratio, seawater salinity, solid-gas ratio (i.e. the added quantity of steel slag) on CO2 absorptivity were studied. Optimal conditions were determined to consist of a liquid–gas ratio of 250-280, an absorber temperature of 27–32°C, an absorber pressure of 1–1.5 atm and a steel slag to gas ratio of 0.09-0.10 for ensuring CO2 absorption capacity above 90%. Two-third of CO2 was captured and stored in calcium carbonate form. Then the energy consumption and cost in the process were analyzed to be 1.017GJ/tCO2 and 76.29RMB/tCO2, respectively. Compare to other absorption processes, this process has lowest system cost.

Mechanism and process study on steel slag enhancement for CO2 capture by seawater

Performance evaluation and environment risk assessment of steel slag enhancement for seawater to capture CO2

Capture CO2 using Steel Slag combined with high salt effluent

Study of CO2 Capture by Seawater and Its Reinforcement

Enhanced Steelmaking Slag Mineral Carbonation in Dilute Alkali Solution

Study on Characteristics of Steel Slag for CO2 Capture

Co-treatment of Waste From Steelmaking Processes: Steel Slag-Based Carbon Capture and Storage by Mineralization

CO2 Sequestration and CaCO3 Recovery with Steel Slag by a Novel Two-Step Leaching and Carbonation Method

Synthesis of Highly Efficient CaO-Based, Self-Stabilizing CO2 Sorbents via Structure-Reforming of Steel Slag.

Acidification Optimization and Granulation of a Steel-Slag-Derived Sorbent for CO2 Capture

Modeling and response surface methodology optimization of reaction parameters for aqueous mineral carbonation by steel slag

Carbon Dioxide Capture and Product Characteristics Using Steel Slag in a Mineral Carbonation Plant

Carbon dioxide mineralization for the disposition of blast-furnace slag: reaction intensification using NaCl solutions: Original Research Article: Carbon dioxide mineralization for the disposition of blast-furnace slag

Direct Gas-Solid Carbonation Kinetics of Steel Slag and the Contribution to in Situ Sequestration of Flue Gas CO(2) in Steel-Making Plants.

Carbon sequestration of steel slag and carbonation for activating RO phase

CO 2 mineralization using basic oxygen furnace slag: process optimization by response surface methodology

Performance of steel slag in carbonation–calcination looping for CO2 capture from industrial flue gas

Carbon dioxide removal efficiency of iron and steel slag in seawater via ocean alkalinity enhancement

Research on Integrated CO2 Absorption-Mineralization and Regeneration of Absorbent Process

Mechanism of ultrasonic enhanced acetic acid efficiently leaching of steel slag and synthesis of calcium carbonate whiskers

Highly efficient CO2 capture with simultaneous iron and CaO recycling for the iron and steel industry