Abstract:The global warming and greenhouse effect are increasingly severe. China is the world's largest CO2 emitter and is facing tremendous pressure to reduce CO2 emission. Analyses of CO2 emission sources in China show that coal-fired power plants, cement plants and steel mills make up the vast majority of CO2 emissions. Therefore, it is important to reduce CO2 emissions in the three industries. In order to reduce the capture cost we propose high salt effluent from the enterprise to absorb CO2. CO2 can be fixed in carbonates with Ca 2+ and Mg 2+ in high salt effluent. CO2 capture by high salt effluent can reach the combination of CO2 capture and storage. There are many steel industries in China. A large amount of slag waste is produced every year and heavy accumulation causes environmental pollution and waste of land resources. The slag with rich alkaline substances can be reinforce CO2 capture by high salt effluent. and carbonate product can be used as raw material for other industries. It achieve resource utilization of steel slag and the combination of CO2 capture and storage, and use waste to treat waste. On-line chromatography method is applied to determine the CO2 solubility in high salt effluent (simulated system) without and with steel slag (simulated system). It is studied on the influence of temperature and salinity on CO2 capture by high salt effluent and found the increase of temperature and salinity adverse to CO2 capture by high salt effluent. It is also studied on the influence of temperature, steel slag concentration, steel slag composition and their synergy on CO2 capture by high salt effluent with steel slag and found the decrease of temperature and the increase of slag concentration favor to CO2 capture, and CaO, MgO and their synergy all promote CO2 capture. Relative to temperature and salinity, the increasing concentration of steel slag has greatly promoted CO2 capture by high salt effluent, and CO2 solubility increases by 1115.56% per 1% increase in steel slag concentration. The thermodynamic model is built to study on CO2 capture by high salt effluent without and with steel slag and the average errors between calculation values and experimental values are less than 5% and explain the experimental results. The influence of temperature and salinity on CO2 capture are achieved by Henry’s constant and ionization constant. The increase of steel slag enhances the alkalinity of the solution and increases the concentration of H2CO3, HCO3 , CO3 2and improves the formation of carbonate, which promotes CO2 capture. CaO and MgO can promote CO2 capture because of high solubility in seawater and MgO is better than CaO in CO2 capture and Fe2O3 and Al2O3 have little effect on CO2 capture because of low solubility in high salt effluent. The kinetics of CO2 absorption in high salt effluent without and with steel slag was studied. The mass transfer coefficient decreases with decrease of pressure and pH. The increase of temperature, decrease of salinity and increase of slag concentration can increase mass transfer coefficient and promote CO2 absorption rate. In composition of steel slag, Fe2O3 can increase CO2 absorption rate. Finally, the process of CO2 capture by high salt effluent without and with steel slag were built by Aspen Plus. The effluence of temperature, pressure, liquid-gas ratio, seawater salinity, solid-gas ratio (i.e. the added quantity of steel slag) on CO2 absorptivity were studied. Optimal conditions were determined to consist of a liquid–gas ratio of 250-280, an absorber temperature of 27–32°C, an absorber pressure of 1–1.5 atm and a steel slag to gas ratio of 0.09-0.10 for ensuring CO2 absorption capacity above 90%. Two-third of CO2 was captured and stored in calcium carbonate form. Then the energy consumption and cost in the process were analyzed to be 1.017GJ/tCO2 and 76.29RMB/tCO2, respectively. Compare to other absorption processes, this process has lowest system cost.

Evaluation of the Carbon Sequestration Potential of Steel Slag in China Based on Theoretical and Experimental Labile Ca

Enhanced Steelmaking Slag Mineral Carbonation in Dilute Alkali Solution

Carbonation of steelmaking slag presents an opportunity for carbon neutral: A review

Direct Gas-Solid Carbonation Kinetics of Steel Slag and the Contribution to in Situ Sequestration of Flue Gas CO(2) in Steel-Making Plants.

Use of steel slag as carbonation material: A review of carbonation methods and evaluation, environmental factors and carbon conversion process

A Review on the Carbonation of Steel Slag: Properties, Mechanism, and Application

Modeling and response surface methodology optimization of reaction parameters for aqueous mineral carbonation by steel slag

Environmental benefit assessment of steel slag utilization and carbonation: A systematic review

An efficient molten steel slag gas quenching process: Integrating carbon solidification and waste heat recovery

Carbon Dioxide Capture and Product Characteristics Using Steel Slag in a Mineral Carbonation Plant

Performance of steel slag in carbonation–calcination looping for CO2 capture from industrial flue gas

Evaluation of Potential Factors Affecting Steel Slag Carbonation

A thorough assessment of mineral carbonation of steel slag and refractory waste

Atrioventricular Node Reentry: Physiology and Radiofrequency Ablation

Research status and future challenge for CO2 sequestration by mineral carbonation strategy using iron and steel slag

Carbon sequestration of steel slag and carbonation for activating RO phase

Performance evaluation and environment risk assessment of steel slag enhancement for seawater to capture CO2

Capture CO2 using Steel Slag combined with high salt effluent

Mineral Sequestration of Co(2) Using Basic Oxygen Furnace (bof) Steelmaking Slag

Environmental, economic and engineering performances of aqueous carbonated steel slag powders as alternative material in cement pastes: Influence of particle size

Improving the Carbonation of Steel Slags Through Concurrent Wet Milling