Abstract:Introduction: Near surface temperature and thermal behavior not only provide information for testing models for thermal evolution of the Moon, quantifying depth at which volatiles might be stable, but are also important for system design for human and robotic exploration of the Moon. Since 1960s, extensive studies about near surface temperature of the Moon were conducted by using theoretical simulation, in situ measurements, and remote sensed observations at in-frared and radio band [1-4]. However, most of previous observations are at infrared band that only contains surface information within 1 µm, and there is almost no systematical study about subsurface temperature. In China's ChangE 1 and 2 missions, four channel microwave radiometers (MRM) were used to measure thermal emission from the lunar surface, from which near surface temperature down to a depth of several meters can be estimated globally [5, 6]. In this study, near surface temperature of the Moon is investigated using ChangE 2 microwave radiometer data. First, factors that affecting high-frequency brightness temperature (TB), such as surface slope, solar albedo, and dielectric constant of regolith, are analyzed. Then, using a two-layer regolith model, thermal emission from lunar surface at high frequency is mod-eled based on radiative transfer theory. Using this model, mean diurnal temperatures for lunar surface and subsurface are inverted from mean diurnal brightness temperature at 19.35 and 37 GHz. Factors that Affecting Lunar Brightness Temperatures: At microwave band, thermal emission from lunar surface depends mainly on depth-dependent temperature and dielectric constant of regolith. During lunar daytime, the steady state surface temperature can be obtained by energy balance between solar radiation and infrared thermal radiation, which is known as Rac-ca's model [7]. Surface slope changes local incidence angle of solar radiation, which results in a change in physical temperature. On the other hand, solar albedo affects the absorbed solar energy by lunar surface, causing a change in surface temperature. As a result of temperature dependent thermal emission, these two factors can affect the observed TB from lunar surface. As an example, Figure 1 shows the effect of surface slope (a) and solar albedo (b) on the observed TB at 37 GHz for lunar noon. The black lines in Figure 1a and 1b indicate the observed TB by CE-2, with their ground tracks represented by the black lines in Figure 1c. The red lines represent the steady state surface temperature that estimated from Racca's model, and the blue lines …

Brightness Temperature Analysis of Mare Marginis Based on CE-2 CELMS Data

A Unified Brightness Temperature Features Analysis Framework for Mapping Mare Basalt Units Using Chang'e-2 Lunar Microwave Sounder (CELMS) Data

Preliminary analysis of mircowave brightness temperature of the luanr surface from change 1 multi-channel radiometer observation and inversion of regolith layer thickness

A New Brightness Temperature Mapping Method for Weakening Latitude Effect With Chang'e-2 MRM Data and Its Geologic Significances

Geological Genesis of a Brightness Temperature Anomaly on Lunar Farside Highlands

Microwave Thermal Emission Features of Mare Orientale Revealed by Celms Data

Analysis of high-frequency brightness temperature of lunar surface from chang ’ e-2 microwave radiometer and investigations of mean diurnal temperature of regolith layer

High Frequency Thermal Emission from the Lunar Surface and Near Surface Temperature of the Moon from Chang’E-2 Microwave Radiometer

Thermophysical properties of surface deposits in Tsiolkovskiy crater and its geologic significance revealed by CE-2 MRM data

Comparative Analysis of Diurnal Thermal Radiation Variation Among Lunar Craters of Different Ages Using CE-2 MRM Data

Study of Surface Deposits in the Schiller–Schickard Cryptomare Region: Insights From CE-2 MRM Data

Analysis of Microwave Brightness Temperature of Lunar Surface and Inversion of Regolith Layer Thickness:Primary Results of Chang-E 1 Multi-Channel Radiometer Observation

Explanations for Unusual Seasonal Variations in Chang’E-2 Microwave Radiometer Datasets of Lunar Double-Shaded Permanently Shadowed Regions

Diurnal Change of MW and IR Thermal Emissions from Lunar Craters with Relevance to Rock Abundance

Microwave Brightness Temperature of Cratered Lunar Surface and Inversions of the Physical Temperature Profile and Thickness of Regolith Layer

Inversion of dielectric properties of the Lunar regolith media with temperature profiles using Chinese Chang'E-1 and Chang'E-2 MW observations

Diurnal change of thermal emission with “hot spots” and “cold spots” of fresh lunar craters observed by Chinese Chang’E-1

Research on Microwave Thermal Emission at Tycho Area and Its Geological Significance

Diurnal Physical Temperature at Sinus Iridum Area Retrieved from Observations of Chinese Chang'E-1 Microwave Radiometer

Thermophysical Features Of The Rumker Region In Northern Oceanus Procellarum: Insights From Ce-2 Celms Data

Mineralogy of northern nearside mare basalts