Abstract:Introduction: Near surface temperature and thermal behavior not only provide information for testing models for thermal evolution of the Moon, quantifying depth at which volatiles might be stable, but are also important for system design for human and robotic exploration of the Moon. Since 1960s, extensive studies about near surface temperature of the Moon were conducted by using theoretical simulation, in situ measurements, and remote sensed observations at in-frared and radio band [1-4]. However, most of previous observations are at infrared band that only contains surface information within 1 µm, and there is almost no systematical study about subsurface temperature. In China's ChangE 1 and 2 missions, four channel microwave radiometers (MRM) were used to measure thermal emission from the lunar surface, from which near surface temperature down to a depth of several meters can be estimated globally [5, 6]. In this study, near surface temperature of the Moon is investigated using ChangE 2 microwave radiometer data. First, factors that affecting high-frequency brightness temperature (TB), such as surface slope, solar albedo, and dielectric constant of regolith, are analyzed. Then, using a two-layer regolith model, thermal emission from lunar surface at high frequency is mod-eled based on radiative transfer theory. Using this model, mean diurnal temperatures for lunar surface and subsurface are inverted from mean diurnal brightness temperature at 19.35 and 37 GHz. Factors that Affecting Lunar Brightness Temperatures: At microwave band, thermal emission from lunar surface depends mainly on depth-dependent temperature and dielectric constant of regolith. During lunar daytime, the steady state surface temperature can be obtained by energy balance between solar radiation and infrared thermal radiation, which is known as Rac-ca's model [7]. Surface slope changes local incidence angle of solar radiation, which results in a change in physical temperature. On the other hand, solar albedo affects the absorbed solar energy by lunar surface, causing a change in surface temperature. As a result of temperature dependent thermal emission, these two factors can affect the observed TB from lunar surface. As an example, Figure 1 shows the effect of surface slope (a) and solar albedo (b) on the observed TB at 37 GHz for lunar noon. The black lines in Figure 1a and 1b indicate the observed TB by CE-2, with their ground tracks represented by the black lines in Figure 1c. The red lines represent the steady state surface temperature that estimated from Racca's model, and the blue lines …

Diurnal Change of MW and IR Thermal Emissions from Lunar Craters with Relevance to Rock Abundance

Diurnal change of thermal emission with “hot spots” and “cold spots” of fresh lunar craters observed by Chinese Chang’E-1

A Radiative Transfer Model for MW Cold and IR Hot Spots of Chang'e and Diviner Observations.

Comparative Analysis of Diurnal Thermal Radiation Variation Among Lunar Craters of Different Ages Using CE-2 MRM Data

Microwave Brightness Temperature of Cratered Lunar Surface and Inversions of the Physical Temperature Profile and Thickness of Regolith Layer

Inversion of Dielectric Properties of the Lunar Regolith Media With Temperature Profiles Using Chang'e Microwave Radiometer Observations

Inversion of dielectric properties of the Lunar regolith media with temperature profiles using Chinese Chang'E-1 and Chang'E-2 MW observations

Analysis of Microwave Brightness Temperature of Lunar Surface and Inversion of Regolith Layer Thickness:Primary Results of Chang-E 1 Multi-Channel Radiometer Observation

High Frequency Thermal Emission from the Lunar Surface and Near Surface Temperature of the Moon from Chang’E-2 Microwave Radiometer

The modeling analysis of microwave emission from stratified media of non-uniform lunar cratered terrain surface for Chinese Chang-E 1 observation

Explanations for Unusual Seasonal Variations in Chang’E-2 Microwave Radiometer Datasets of Lunar Double-Shaded Permanently Shadowed Regions

Thermophysical properties of surface deposits in Tsiolkovskiy crater and its geologic significance revealed by CE-2 MRM data

Research on Microwave Thermal Emission at Tycho Area and Its Geological Significance

Analysis of high-frequency brightness temperature of lunar surface from chang ’ e-2 microwave radiometer and investigations of mean diurnal temperature of regolith layer

Preliminary analysis of mircowave brightness temperature of the luanr surface from change 1 multi-channel radiometer observation and inversion of regolith layer thickness

Diurnal Physical Temperature at Sinus Iridum Area Retrieved from Observations of Chinese Chang'E-1 Microwave Radiometer

Unveiling the secrets of the mid-infrared Moon

Geological Genesis of a Brightness Temperature Anomaly on Lunar Farside Highlands

Chang'E‐4 rover spectra revealing micro‐scale surface thermophysical properties of the Moon

Thermal modeling of the lunar regolith at the Chang'E‐4 landing site

Analyzing the Topographic Effects of the Lunar PSR on Radiometric Observations Using a Microwave Radiation Model With Coherent Surface Scattering