Abstract:An understanding of the high-temperature processes, such as sintering, remains a challenge despite its paramount importance, and has yet to be achieved by the scientific community. Scanning electron microscopy is a valuable technique for investigating morphological changes, including elemental composition, by means of an energy-dispersive X-ray detector associated with these processes, with high resolution in-situ . Historically, this technique has been limited to experiments conducted at ambient temperature. However, by integrating scanning electron microscopy with a MEMS® heating chip, this limitation can be overcome, enabling the study of solid-state processes at temperatures of up to 1 200°C. This study demonstrates one potential application of in-situ scanning electron microscopy – the densification of La 1-x Sr x MnO 3-δ : (ZrO 2 :Y 2 O 3 ) composite. This material, employed as an oxygen electrode in solid oxide cells, exhibits a complex microstructure. Achieving a balance between effective particle interconnection, ensuring high electric conductivity, and efficient mass transport through its porous structure is crucial. A comprehensive understanding of microstructure and surface composition evolution during the sintering process is vital to addressing trade off when optimizing densification conditions. It was shown that the densification of La 1-x Sr x MnO 3-δ : (ZrO 2 :Y 2 O 3 ) composite occurs in two steps. At 900°C a significant additional porosity emerged due to the La 1-x Sr x MnO 3-δ phase shrinkage (densification). The main densification process at 1 150°C then acts as a self-healing mechanism, leading to the formation of a well-interconnected microstructure. Interparticle ligament formation is exclusively induced by the La 1-x Sr x MnO 3-δ phase. Notably, no common degradation processes, such as La 2 Zr 2 O 7 formation, were observed under the experimental conditions employed. This study underscores the promise of scanning electron microscopy with a heating chip extension for in-situ investigations pertinent to various high-temperature technologies.

Surface Degradation of Mg 2 X-Based Composites at Room Temperature: Assessing Grain Boundary and Bulk Diffusion Using Atomic Force Microscopy and Scanning Electron Microscopy

Performance Degradation and Protective Effects of Atomic Layer Deposition for Mg‐based Thermoelectric Modules

Effect of AFM ordering on ThermoelectricResponses of Mg3X2 (X : C, Si, Ge) monolayers : ADFT Insight

Effect of AFM ordering on thermoelectric responses of Mg3X2(X: C, Si, Ge) monolayers : a DFT insight

Evolution of Nanometer-Scale Microstructure within Grains and in the Intergranular Region in Thermoelectric Mg3(Sb, Bi)2 Alloys

Manifestation of the structural stability of Mg-doped Zn4Sb3 via atomic fine structure investigation

Interface and Surface Engineering Realized High Efficiency of 13% and Improved Thermal Stability in Mg3Sb1.5Bi0.5‐Based Thermoelectric Generation Devices

Intrinsic Mechanical Behavior of MgAgSb Thermoelectric Material: an Ab Initio Study

Exploring the degradation behavior of MgXAg alloys by in vitro electrochemical methods

High-performance magnesium-based thermoelectric materials: Progress and challenges

High-performance Mg3Sb2-based thermoelectrics with reduced structural disorder and microstructure evolution

Chemical stability and degradation mechanism of Mg3Sb2-xBix thermoelectrics towards room-temperature applications

A Study on the Characteristics of Mg2Si Films Prepared by Electron Beam Evaporation Technique

Opportunities of combinatorial thin film materials design for the sustainable development of magnesium-based alloys

In Situ Investigations of Structures Evolution of Mg Doped Zn4Sb3

Low-Cost Magnesium-Based Thermoelectric Materials: Progress, Challenges, and Enhancements

Investigation of the Inner Microstructure of Composite Materials during their Densification by Scanning Electron Microscopy – LSM:YSZ Electrode Case Study

Developing Contacting Solutions for Mg2Si1- xSn x-Based Thermoelectric Generators: Cu and Ni45Cu55 as Potential Contacting Electrodes

Elaborating the Crystal Structures of Mgagsb Thermoelectric Compound: Polymorphs and Atomic Disorders

In-situ Surface Transformation of Magnesium to Protect Against Oxidation at Elevated Temperatures

In situ AFM of interfacial evolution at magnesium metal anode