Abstract:In the context of the Laser Interferometer Space Antenna (LISA), the laser subsystems exhibit frequency fluctuations that introduce significant levels of noise into the measurements, surpassing the gravitational wave signal by several orders of magnitude. Mitigation is achieved by means of time-shifting individual measurements in a data processing step known as time-delay interferometry (TDI). The suppression performance of TDI relies on accurate knowledge and consideration of the delays experienced by the interfering lasers. While considerable efforts have been dedicated to the accurate determination of inter-spacecraft ranging delays, the sources for delays onboard the spacecraft have been either neglected during TDI processing or assumed to be known. Contrary to these assumptions, analog delays of the phasemeter front end and the laser modulation are not only large but also prone to change with temperature and heterodyne frequency. This motivates our proposal for a novel method enabling a calibration of these delays on-ground and in-space, based on minimal functional additions to the receiver architecture. Specifically, we establish a set of calibration measurements and elucidate how these measurements are utilized in data processing, leading to the mitigation of the delays in the TDI Michelson variables. Following a performance analysis of the calibration measurements, the proposed calibration scheme is assessed through numerical simulations. We find that in the absence of the calibration scheme, the assumed drifts of the analog delays increase residual laser noise at high frequencies of the LISA measurement band. A single, on-ground calibration of the analog delays leads to an improvement by roughly one order of magnitude, while recalibration in space may improve performance by yet another order of magnitude. Towards lower frequencies, ranging error is always found to be the limiting factor for which countermeasures are discussed. https://doi.org/10.1103/PhysRevD.109.083024 © 2024 American Physical Society

ADC non-linear errors correction in thermal diagnostics for the LISA mission

An Inaccuracy of +/- 0.5 degrees C Digital Temperature Sensor From-40 degrees C to 125 degrees C With Curvature Correction

A BJT-based SAR Temperature Sensor with a 5.12 pJ.K-2 Resolution FoM from-40 degrees C to 125 degrees C

An 18-Bit 2MSPS SAR ADC with Double Passive Noise-Shaping Calibration

On-ground tests of LISA PathFinder thermal diagnostics system

Compensation of front-end and modulation delays in phase and ranging measurements for time-delay interferometry

Subtraction of temperature induced phase noise in the LISA frequency band

Noise characterization of an atomic magnetometer at sub-millihertz frequencies

Sensor noise in : Laser frequency noise and its coupling to the optical test mass readout

Identifying and Addressing Nonstationary LISA Noise

Design of the magnetic diagnostics unit onboard LISA Pathfinder

Analytic Model and Simulations of Residual Laser Noise after Time-Delay Interferometry in LISA

Sensor noise in LISA Pathfinder : An extensive in-flight review of the angular and longitudinal interferometric measurement system

Design of Dedicated Tilt-to-Length Calibration Maneuvers for LISA

Low-frequency noise characterization of a magnetic field monitoring system using an anisotropic magnetoresistance

Improving the Environmental Temperature Adaptability of an Electric Temperature Measurement Subsystem by Matching Temperature Coefficients of Substitutable Resistors

Ranging Sensor Fusion in LISA Data Processing: Treatment of Ambiguities, Noise, and On-Board Delays in LISA Ranging Observables

Laser noise residuals in LISA from onboard processing and time-delay interferometry

A BJT-Based 0.08-mm2 Oversampling SAR Temperature-to-Digital Converter for Thermal Drift Compensation in MEMS Inertial Sensors

Inflight magnetic characterization of the test masses onboard LISA Pathfinder