Abstract:High efficiency and environment-friendly elastocaloric solid-state cooling has emerged as a promising alternative to traditional vapor-compression refrigeration. Owing to the high entropy change during martensite transformation, NiTi shape memory alloy (SMA) is a competitive candidate for the core components of solid-state refrigeration systems. However, main bottlenecks for the development of NiTi SMA based refrigeration systems are their relatively low elastocaloric strength and the requirement of high driving force. In this work, the elastocaloric effect of NiTi SMA helical springs with three geometrical configurations are investigated experimentally at first. It is found that the elastocaloric performance can be tailored by changing the spring geometrical parameters and the magnitude of applied load. Giant cooling temperature of 12.5K and elastocaloric strength of 0.31K/MPa are observed for the helical spring with a spring index of 7.7 under an ultra-low tensile driving force of 71 N. The elastocaloric strength reported in this work is ten times larger than that observed in the NiTi wires, rods, tubes, sheets and films subjected to a tensile or compressive loading, and twice larger than that in the NiTi wires under a bending deformation mode. Then, a three-dimensional (3D) thermodynamic-consistent constitutive model within the finite strain framework and considering the thermo-mechanical coupling effect is developed. The proposed model is further implemented into the finite element program ABAQUS by writing a user-defined material subroutine (UMAT). Finally, simplified analytical relations among the cooling temperature, maximum driving force, geometrical parameters of the springs and applied displacement are derived. Comparing the predictions with the experimental data, it is found that the influences of geometrical parameters and loading level on the elastocaloric strength of NiTi SMA helical spring can be well captured by both the finite element analysis and proposed analytical relation. This work shows a potential for developing the cooling technology with high elastocaloric strength and low driving force, and provides a theoretical guidance to design and assess the cooling device manufactured by SMA spring.

Torsional refrigeration by twisted, coiled, and supercoiled fibers

Twistocaloric modeling of elastomer fibers and experimental validation

Efficient roller-driven elastocaloric refrigerator

A compact elastocaloric refrigerator

Elastocaloric Heat Pump by Twist Induced Periodical Non‐Linear Stress for Low Hysteresis and High Carnot Efficiency

Development Of Elastocaloric Cooling Technology

A Novel Refrigeration Cycle With A Vortex Tube To Attain Three Different Evaporation Temperatures

High Cycle‐Life Twistocaloric Cooling of Poly‐p‐Phenylene Benzodioxole Fibers

Low-force elastocaloric refrigeration via bending

Highly Efficient Mechanocaloric Cooling Using Colossal Barocaloric Plastic Crystals

Highly efficient grooved NiTi tube refrigerants for compressive elastocaloric cooling

Solid-state cooling by elastocaloric polymer with uniform chain-lengths

Continuous operating elastocaloric air-cooling device

A Heat Driven Elastocaloric Cooling System

High-performance multimode elastocaloric cooling system

High performance of carbon nanotube elastocaloric refrigerators over a large temperature span

High performance of carbon nanotube refrigerators over a large temperature span

Solid-state cooling with high elastocaloric strength and low driving force via NiTi shape memory alloy helical springs: Experiment and theoretical model

Continuous and efficient elastocaloric air cooling by coil-bending

State-of-the-art and Prospects of Elastocaloric Cooling Technology

The Study Of A Small Air Refrigerator With Plate Foil Aerodynamic Bearings Turboexpander