Abstract:The present work presents a 2D and 3D modelling of the neutral gas flow in the sub-divertor region of the W7-X. The investigations have been done using the DIVGAS code. The complex 2D and 3D geometries of the divertor components in the sub-divertor region have been considered and the Standard and High-Iota magnetic configurations have been numerically simulated. The main objective of this study is to investigate the dynamics of neutral particles in the sub-divertor region including the effects due to geometry and toroidal and poloidal leakages located at the divertor targets and baffles on the achieved pumping efficiency. A sensitivity analysis has been performed for the effect of various geometrical and flow parameters on the pumping performance, under different plasma scenarios. The considered incoming fluxes in the sub-divertor range between 1020 to 1022 (H2/s). The main conclusions, which can be extracted from the present numerical analysis could be summarized as follows; a large fraction of incoming neutral particle flux i.e. > 70% on the low iota side and > 40% for the high iota side is leaked back to the main divertor region, while higher incoming neutral fluxes facilitate the increase of the pumped flux as well as the decrease of the outflux. It has been estimated that a small fraction ~3-4% of the incoming neutral flux is being pumped via the turbo-molecular pumps. The closure of the toroidal leakages as well as the inclination of the pumping gap panel by 9 o facilitate the increase of the pumped flux, but considering the all the engineering constraints, the latter option seems to be more easy to be implemented. For low incoming neutral fluxes (~1020 H2/s) and for the case of AEH section, free molecular flow conditions are estimated and therefore neutral-neutral collisions could be neglected. For higher incoming neutral fluxes and for both AEH and AEP sections neutral-neutral collisions play a significant role in the flow establishment. A comparison with available experimental measurements of the neutral pressure in the sub-divertor has been performed for Standard and High-Iota plasma discharges. The 3D DIVGAS simulations predict qualitatively the experimental data with relative deviation between 25 and 63%. All the above numerical findings will actively support the optimization of the W7-X particle exhaust, in view of the experimental campaign OP2.

A Monte-Carlo model of neutral-particle transport in diverted plasmas

Kinetic modeling of the plasma-wall interaction in the DTT divertor region

Hilbert expansion based fluid models for kinetic equations describing neutral particles in the plasma edge of a fusion device

Comparison of the TEP method for neutral particle transport in the plasma edge with the Monte Carlo method

Self-consistent multi-component simulation of plasma turbulence and neutrals in detached conditions

Development of Monte Carlo neutral transport code and the application to methane seeding plasma detachment

Runaway Electron Effects

Modeling transient edge plasma transport with dynamic recycling

A two-dimensional hybrid model of the Hall thruster discharge

Monte Carlo Collision method for low temperature plasma simulation

Multiscale simulation of neutral particle flows in the plasma edge

Linear transport in stochastic media. Application to neutral transport in turbulent plasmas

Numerical simulation of neutral gas dynamics in the W7-X sub-divertor

Adjoint Monte Carlo calculation of charged plasma particle flux to wall

Monte Carlo simulations of charged particle transport in plasmas: A fast single-scattering model

Comparison analysis of 1D/2D/3D neutronics modeling for a fusion reactor

DSMC simulations of neutral gas flow in the DTT particle exhaust system

Neoclassical flows in deuterium-helium plasma density pedestals

Monte Carlo hydrodynamic simulation of neutral radical transport in low pressure remote plasma activated chemical vapor deposition

Thermal-to-fusion Neutron Convertor and Monte Carlo Coupled Simulation of Deuteron/triton Transport and Secondary Products Generation

An ion species model for positive ion sources - part I description of the model