Abstract:As the market share of electric vehicles continues to expand, fire accidents due to impacts from the power battery located at the bottom of the electric vehicles are receiving increasing attention. Lithium-ion batteries, as the mainstream choice of power battery for electric vehicles solving the problem that they are prone to thermal runaway due to damage when impacted, are the key to preventing and controlling fire accidents in electric vehicles. To address the protective problem of the bottom power battery of electric vehicles when it is impacted by road debris, two new types of sandwich structures with an enhanced regular hexagonal structure and semicircular arch structure as the core layer, respectively, are innovatively proposed in this article. They are used to protect the bottom power battery of electric vehicles and are compared with the traditional homogeneous protective structure in terms of protective performance. A local finite element simulation (FEM) of an electric vehicle containing the necessary components was established for simulation. Stress distribution, deformation, and energy absorption data for each component of an electric vehicle assembled with a protective structure when subjected to a bottom impact were obtained safely and cost-effectively. Three evaluation coefficients, namely, the cell shape variable (Bcmax), the protective effect parameter (ƒPE), and the total energy absorption of the structure (Ea), are proposed to compare and analyze the simulation results of different protective structures under equal mass conditions. The maximum values of the battery deformation of arched sandwich construction and reinforced honeycomb sandwich construction were 0.35 mm and 0.40 mm, respectively, which are much smaller than that of the maximum deformation of the battery under the protection of a homogeneous protective structure, which is 0.62 mm. Their protective effect parameters are 43.55 and 35.48, respectively, which proves that the optimization degree of the protective structure of the bottom of the electric vehicle after the application of the new structure is 35% or more. The total energy absorptions of the two structures are 91.77 J and 87.19 J, respectively, accounting for more than 70% of the kinetic energy in the system, which proves that the deformation of the sandwich structure can effectively absorb the kinetic energy of the collision between the road obstacle and the bottom of the car. The final results show that the arched sandwich structure showed the best impact resistance in the simulation, which can be used for the power battery’s protective structure on the electric vehicle’s bottom. This study fills a gap in local finite element modeling in electric vehicle crash simulations and provides ideas for fire prevention designs of electric vehicle structures.

Crashworthiness Analysis of Electric Vehicle With Energy-Absorbing Battery Modules

Crashworthiness Design Optimization for an Evtol Aircraft.

Nature-Inspired Cellular Structure Design for Electric Vehicle Battery Compartment: Application to Crashworthiness

Crush and crash analysis of an automotive battery-pack enclosure for lightweight design

Study on the Battery Safety in Frontal Collision of Electric Vehicle

Optimization and Structural Analysis of Automotive Battery Packs Using ANSYS

Frontal crashworthiness structure analysis and optimization of electric vehicle

Damage Assessment Method of Battery Pack of Electric Vehicle in Undercarriage Collision

Optimization Study of Fire Prevention Structure of Electric Vehicle Based on Bottom Crash Protection

Integrated Crashworthiness Analysis of Electric Vehicle Battery Shells and Chassis: A Finite Element Study with Abaqus

Crashworthiness Evaluation of Electric Vehicle Battery Packs Using Honeycomb Structures and Explicit Dynamic Analysis

Topology optimization for crashworthiness and structural design of a battery electric vehicle

Lightweight Design of an Automotive Battery-Pack Enclosure via Advanced High-Strength Steels and Size Optimization

Multi-objective lightweight design of automotive battery pack box for crashworthiness

Structural Analysis of Battery Pack Box for New Energy Vehicles Based on the Application of Basic Foam Aluminum Materials

Multi-objective optimization design of B-pillar and rocker sub-systems of battery electric vehicle

Mechanical safety prediction of a battery-pack system under low speed frontal impact via machine learning

Thermal–Electrical–Mechanical Coupled Finite Element Models for Battery Electric Vehicle

Investigation of Crashworthiness of Carbon Fiber-Based Electric Vehicle Battery Enclosure Using Finite Element Analysis

INFLUENCE OF MECHANICAL INTERACTION BETWEEN LITHIUM-ION POUCH CELLS IN A SIMPLIFIED BATTERY MODULE UNDER IMPACT LOADING