Abstract:A virtual prototype of the moving beam balancing system of a heavy-duty hydraulic press working under die forging function is built with Adams, AMESim and Simulink, and the balancing control process is analyzed using this prototype. The moving beam of the heavy-duty hydraulic press may tilt due to the eccentric load during the die forging processing, and thus affect the forging quality and the safety of the press. So it is necessary to research the beam balancing control process. Compared to the traditional methods based on simplified mathematical models, virtual prototype technology can obtain a co-simulation model, avoid tedious formula derivation and solving work, and save test time and cost. Based on the analysis of the working principle of balancing system, this paper establishes a dynamical model of the moving beam, a hydraulic circuit model of the single balancing system and a controller model using Adams, AMESim and Simulink, respectively. Then a virtual prototype is built using the three models via co-simulation interface files. The eccentric load signal is constructed in AMESim according to the variation of eccentric load during die forging process. By adjusting the controller parameters, the rapid balancing of the moving beam under eccentric load conditions is realized, and high precision of dynamic balancing and steady equilibrium is obtained. The simulation results show that the single balancing unit can achieve effective balancing of the moving beam, and the co-simulation analysis method based on the virtual prototype built with Adams, AMESim and Simulink is feasible in the research of the synchronous rectification of the moving beam. This work is a useful exploration in the research of synchronous rectification of moving beams.

Stiffness Matching of Cantilever Beam at Multipositions for Diaphragm Volume Pump Driving

Investigation of a Complete Squeeze-Film Damping Model for MEMS Devices

Stiffness match between electro-thermal micro-actuators and compliant amplifiers

Dynamic Flexoelectric Actuation and Vibration Control of Beams

Design and Test a Pneumatically Actuated Microgripper Based on Structural Stiffness.

Design of a Novel Compliant Constant-Force Mechanism with High Lateral Stiffness

Development of Elastic Diaphragm Structure for Ultra-low Stiffness Probe and Mechanical Properties Testing Method

Tilted folded-beam suspension for extending the stable travel range of comb-drive actuators

Dynamic Behavior of Perforated Parallel-Plate Actuator under Squeeze Film Damping Effect

Effect of Load Stiffness on the Output of Thermal Microactuators

Analytical Stiffness Model of a Fluid-Filled U-shaped Bellows Based Three-Parameter Fluid Damper for Micro-Vibration Suppression

Dynamic Modeling and Active Vibration Control of Cantilever Beam with Piezoelectrics

CO-SIMULATION RESEARCH OF THE BALANCING CONTROL OF THE MOVING BEAM OF A HEAVY HYDRAULIC PRESS DURING THE DIE FORGING PROCESS

Numerical Analysis Of A Composite Diaphragm Microactuator

An improved structural design for accelerometers based on cantilever beam-mass structure

A novel bridge-type compliant displacement amplification mechanism under compound loads based on the topology optimisation of flexure hinge and its application in micro-force sensing

A Theoretical Solution of Resonant Circular Diaphragm-Type Piezoactuators with Added Mass Loads

Stiffness modeling of compliant parallel mechanisms and applications in the performance analysis of a decoupled parallel compliant stage

Fabrication of low-stress low-stiffness leveraged cantilever beam for bistable mechanism

Design and Sensitivity Analysis of a Micro-Resonant Accelerometer with Adjustable Stiffness

Design and optimization of compliant constant-torque mechanisms utilizing arbitrary pre-curved beams