Abstract:Purpose: The successful development of controlled release formulations for proteins requires that the protein not be denatured during the manufacturing process. The major objective was to develop formulations that stabilize two recombinant human proteins, human growth hormone (rhGH) and interferon-gamma (rhIFN-gamma), at high protein concentrations (> 100 mg/mL) in organic solvents commonly used for microencapsulation, methylene chloride and ethyl acetate. Methods: Several excipients were screened to obtain the maximum solubility of each protein. These formulations (aqueous, lyophilized, milled, spray dried, or isoelectric precipitate) were then rapidly screened by emulsification in the organic solvent followed by recovery into excess buffer. Additional screening was performed with solid protein that was suspended in the organic solvent and then recovered with excess buffer. The recovery of native protein was determined by native size exclusion chromatography (SEC-HPLC) and circular dichroism (CD). The selected formulations were encapsulated in polylactic-coglycolic acid (PLGA) microspheres by either water-in-oil-in-water (W/O/W) or solid-in-oil-in-water (S/O/W) methods. The initial protein released from the microspheres incubated at physiological conditions was analyzed by SEC-HPLC, CD, and biological assays. Results: The stability of a given formulation in the rapid screening method correlated well with stability during encapsulation in PLGA microspheres. Formulations of rhGH containing Tween 20 or 80 resulted in lower recovery of native protein, while trehalose and mannitol formulations (phosphate buffer, pH 8.0) yielded complete recovery of native rhGH. Other additives such as carboxymethyl cellulose, gelatin, and dextran 70 were not effective stabilizers, and polyethylene glycol provided some stabilization of rhGH. Trehalose/rhGH (1:4 mass ratio) and mannitol/rhGH (1:2 mass ratio) formulations (potassium phosphate buffer, pH 8.0) were lyophilized, reconstituted to 200 and 400 mg/mL rhGH, respectively, and then encapsulated in PLGA microspheres. The protein was released from these microspheres in its native state. Lyophilized formulations of rhGH yielded analogous results indicating the ability of trehalose and mannitol to stabilize the protein. Small solid particles of rhGH generated by spray drying (both air and freeze-drying) formulations containing Tween 20 or PEG were stable in ethyl acetate, but not methylene chloride. Similar results were also obtained with rhIFN-gamma (137 mg/mL in succinate buffer, pH 5.0), where both mannitol and trehalose were observed to stabilize the protein during exposure to the organic solvents resulting in the release of native rhIFN-gamma from PLGA microspheres. Conclusions: The rapid screening method allowed the development of stable concentrated protein solutions or solid protein formulations that could be successfully encapsulated in PLGA microspheres. The excipients observed to stabilize these proteins function by preferential hydration of the protein, and in the dry state (e.g., trehalose) may stabilize the protein via water substitution yielding a protective coating around the protein surface. Studies of other proteins should provide further insight into this mechanism of protein stabilization during encapsulation.

Preparation of antibody-loaded protein microbeads for pulmonary delivery via Shirasu porous glass membrane emulsification and freeze drying

Preparation and Characterization of Supermacroporous Polyacrylamide Cryogel Beads for Biotechnological Application

Preparation of polyacrylamide supermacropore cryogel beads and its bicompatibility and adsorption behavior

Ganoderma Lucidum Polysaccharide Loaded Sodium Alginate Micro-Particles Prepared Via Electrospraying in Controlled Deposition Environments

Preparation and Characterization of Composite Hydrogel Beads Containing Sericin and Sodium Alginate

Characterization and morphological analysis of protein-loaded poly(lactide-co-glycolide) microparticles prepared by water-in-oil-in-water emulsion technique

Core-Shell Nanoparticles Fabricated By Tri-Capillary Coaxial Electrospray And Template Removal Method For Protein Delivery

Glassy Surfactants Enable Ultra-High Concentration Biologic Therapeutics

Inhalable microparticle platform based on a novel shell-forming lipid excipient and its feasibility for respirable delivery of biologics

Preparation of protein-loaded sustained-release microspheres via 'solid-in-oil-in-hydrophilic oil-in-ethanol (S/O/hO/E)' emulsification

Preparation of uniform sized chitosan microspheres by membrane emulsification technique and application as a carrier of protein drug

Preparation of Injectable Sodium Alginate/Platelet Rich Plasma Porous Microcarriers

Engineered polymeric excipients for enhancing the stability of protein biologics: Poly(N-isopropylacrylamide)-poly(ethylene glycol) (PNIPAM-PEG) block copolymers

Identification of Stability Constraints in the Particle Engineering of an Inhaled Monoclonal Antibody Dried Powder

In-use stability of rituximab and IVIG during intravenous infusion: Impact of peristaltic pump, IV bags, flow rate, and plastic syringes

Stable formulations of recombinant human growth hormone and interferon-gamma for microencapsulation in biodegradable microspheres

Microchannel liquid-flow focusing and cryo-polymerization preparation of supermacroporous cryogel beads for bioseparation

Microfluidic Preparation of Nanoparticles Using Poly(ethylene Glycol)-distearoylphosphatidylethanolamine for Solubilizing Poorly Soluble Drugs

Freezing-mediated formation of supraproteins using depletion forces

Microencapsulation of protein drugs for drug delivery: strategy, preparation, and applications

Subvisible Particles Derived by Dropping Stress Enhance Anti-PEG Antibody Production and Clearance of PEGylated Proteins in Mice