Abstract:PurposeTo understand the mechanism of spherical microparticle formation during lyophilizing a tert-Butyl alcohol (TBA)/water solution of a zinc peptide adduct.MethodA small peptide, PC-1, as well as zinc PC-1 at (3:2) and (3:1) ratios, were dissolved in 44% (wt.%) of TBA/water, gradually frozen to −50°C over 2 h (“typical freezing step”), annealed at −20°C for 6 h (“annealing step”), and subsequently lyophilized with primary and secondary drying. Zinc peptide (3:1) lyophile was also prepared with quench cooling instead of the typical freezing step, or without the annealing step. Other TBA concentrations, i.e., 25%, 35%, 54% and 65%, were used to make the zinc peptide (3:1) adduct lyophile with the typical freezing and annealing steps. The obtained lyophile was analyzed by Scanning Electron Microscopy (SEM). The zinc peptide solutions in TBA/water were analyzed by Differential Scanning Calorimeter (DSC). The surface tension of the TBA/water co-solvent system was measured by a pendant drop shape method.ResultsWith typical freezing and annealing steps, the free peptide lyophile showed porous network-like structure that is commonly seen in lyophilized products. However, with increasing the zinc to peptide ratio, uniform particles were gradually evolved. Zinc peptide (3:1) adduct lyophiles obtained from 25%, 35% and 44% TBA exhibit a distinctive morphology of uniform and spherical microparticles with diameters of ∼3–4 μm, and the spherical zinc peptide particles are more predominant when the TBA level approaches 20%. Adopting quench cooling in the lyophilization cycle leads to irregular shape fine powders, and eliminating the annealing step causes rough particles surface. When TBA concentration increases above 54%, the lyophiles demonstrate primarily irregular shape particles.ConclusionsA proposed mechanism of spherical particle formation of the 3:1 zinc peptide encompasses the freezing of a TBA/water solution (20–70% TBA) causing the formation of a TBA hydrate phase (“dispersed TBA hydrate”). Decreasing the temperature further causes the formation of a eutectic mixture between TBA hydrate (“eutectic TBA hydrate”) and water. Due to its low aqueous solubility, the zinc peptide adduct accumulates in both of the dispersed and eutectic TBA hydrate phases to form a hydrophobic “oil” phase. Since the eutectic TBA hydrate phase is surrounded by ice, a “solid emulsion” forms to lower the interfacial energy, and gives rise to spherical zinc peptide particles upon solvent sublimation. Possibility of liquid–liquid phase separation during freeze-drying was also investigated, and no evidence was found to support this alternative mechanism.

Freezing-mediated formation of supraproteins using depletion forces

Application of a thermodynamic model to the prediction of phase separations in freeze-concentrated formulations for protein lyophilization

Preparation of Polysaccharide Glassy Microparticles with Stabilization of Proteins.

Mechanical release of homogenous proteins from supramolecular gels

Freeze–thaw characterization process to minimize aggregation and enable drug product manufacturing of protein based therapeutics

Safe Freeze–Thaw of Protein Drug Products: A QbD Approach

An Effective Approach to Prepare Uniform Protein–zn2+nanoparticles under Mild Conditions

Spontaneous and Instant Formation of Highly Stable Protein–nanoparticle Supraparticle Co-Assemblies Driven by Hydrophobic Interaction

Fundamentals of the Spray Freezing of Foods - Microstructure of Frozen Droplets

Stabilisation and Encapsulation of Protein into Biodegradable Microspheres with Zinc Ion and Protein in Polyethylene Glycol Solution Formed Nanoparticles by Freeze-Drying

Novel ultra-rapid freezing particle engineering process for enhancement of dissolution rates of poorly water-soluble drugs

Reconsidering freeze-induced protein aggregation: Air bubbles as the root cause of ice-water interface stress

The importance of heat flow direction for reproducible and homogeneous freezing of bulk protein solutions

Effect of the Freezing Step in the Stability and Bioactivity of Protein-Loaded PLGA Nanoparticles Upon Lyophilization

Development of Dextran Nanoparticles for Stabilizing Delicate Proteins.

Formation of Zinc–Peptide Spherical Microparticles During Lyophilization from tert-Butyl Alcohol/Water Co-solvent System

Optimization of High-Concentration Endostatin Formulation: Harmonization of Excipients' Contributions on Colloidal and Conformational Stabilities.

Microencapsulation of Protein-Loaded Polysaccharide Particles Within Poly(D,L-Lactic-Co-Glycolic Acid) Microspheres Using S/O/W: Characterization and Release Studies

Nanocrystallites Modulate Intermolecular Interactions in Cryoprotected Protein Solutions

Therapeutic surfactant-stripped frozen micelles